Spectra nTier500 Installation Manual
Rack-mount
Hide thumbs
Also See for nTier500:
- User manual (184 pages) ,
- Quick reference manual (18 pages) ,
- Replacement manual (9 pages)
Subscribe to Our Youtube Channel
Related Manuals for Spectra nTier500
Summary of Contents for Spectra nTier500
- Page 1 Spectra nTier500 and nTier500 VTL Rack-mount Installation Guide SpectraLogic.com...
- Page 2 THE IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, BOTH OF WHICH ARE EXPRESSLY DISCLAIMED. In no event shall Spectra Logic be liable for any loss of profits, loss of business, loss of use or data, interruption of business, or for indirect, special, incidental or consequential damages of any kind, even if Spectra Logic has been advised of the possibility of such damages arising from any defect or error.
-
Page 3: Before You Begin
A 2-post-Rack wird nicht das Gewicht der nTier (48 cm) Rack. If you are not installing any other equipment in the rack, install the Spectra nTier Warning appliance near the bottom of the rack to prevent the rack from being top-heavy. - Page 4 To reduce the risk of personal injury or damage to equipment: Warning Extend leveling jacks to the floor. Ensure that the full weight of the rack rests on the leveling jacks. Install stabilizing feet on the rack. In multiple-rack installations, secure racks together. Extend only one rack component at a time.
- Page 5 2. Press up on the latch as shown in Figure 1 to release the latch. 3. Pull the slider completely out of the outer rail. 4. Repeat steps 1–3 for the second rail assembly. April 2009 Spectra nTier500 and nTier500 VTL...
- Page 6 Install the Sliders on the Chassis 1. Remove the nTier appliance from its bag and place it on a sturdy work surface where you can reach both sides of the chassis. Having two people for this task simplifies lifting and moving the chassis. 2.
- Page 7 Figure 5 Adjust the position of the extender attached to rail end. 2. Position one of the rails against the inside of the rack with the extender toward the back of the rack. April 2009 Spectra nTier500 and nTier500 VTL...
- Page 8 3. Adjust the position of the extender so that the assembled rail just fits in the inside distance from the front mounting holes of your rack to the back mounting holes. Note: Using a measuring tape simplifies determining the length required for the rails to fit inside the rack.
- Page 9 Figure Clip nut Empty hole Mounting screws for nut plate Empty hole Clip nut Figure 8 Attach clip nuts to the front of the rack. April 2009 Spectra nTier500 and nTier500 VTL...
- Page 10 NSTALL THE N PPLIANCE INTO THE The nTier appliance weighs approximately 54 lb. (25 kg) without drives installed. Warning Use extreme caution when moving it. Always use two people, one on each side, when lifting or moving it. German: Die nTier Gerät wiegt ca 25 kg., ohne Laufwerke installiert. Verwenden Sie extreme Vorsicht walten lassen, wenn sie abwandern.
- Page 11 Screw Figure 10 Secure the chassis to the rack (left side shown) 3. The rack installation is now complete. Continue with the installation as described in the documentation that accompanied your nTier appliance. April 2009 Spectra nTier500 and nTier500 VTL...
- Page 12 Notes Rack-Mounting Instructions 90990047...
Need help?
Do you have a question about the nTier500 and is the answer not in the manual?
Questions and answers