Subscribe to Our Youtube Channel
Summary of Contents for Liebert Air Flow Enhander XDA
- Page 1 Liebert XDA Air Flow Enhancer ™ User Manual Precision Cooling For Business-Critical Continuity...
-
Page 3: Table Of Contents
TABLE OF CONTENTS 1.0 Product Description ......1 1.1 Features & Benefits ........1 2.0 Installation . -
Page 5: Product Description
The Liebert XDA is also available as a factory-installed option on Lie- bert Foundation™ cabinets. Features & Benefits •... -
Page 6: Installation
NSTALLATION The Liebert XDA can be attached to most equipment cabinet doors 60" tall or taller. The unit typically is installed on the outside of a cabi- net’s rear door, generally used to discharge heat generated from the cabinet. If aisle space is insufficient for exterior mounting, and space is avail- able inside the cabinet, the XDA may be installed on the inside of the door. -
Page 7: Required Tools
2.2.1 Required Tools • Phillips screwdriver • Pliers • Scissors Mounting the XDA on the Exterior of the Rear Cabinet Door 2.3.1 Prepare to Install the Unit 1. Determine the desired mount- ing position on the door. 2. Attach the mounting bracket to the top of the XDA, positioning the bracket to obtain the desired mounting height. -
Page 8: Mount The Unit And Attach It To The Cabinet
2.3.2 Mount the Unit and Attach it to the Cabinet 1. Lift the unit with bracket attached and hang it on the door, as shown at right. Ensure that the bracket rests safely on top of the top edge of door. 2. -
Page 9: Mounting The Xda On The Interior Of The Rear Cabinet Door
3. Position the angles so their mounting surfaces are near the front of the XDA. (This is the air discharge side, which has the Liebert logo and longer, horizontal slots over the fans.) To reverse the position of the mounting... -
Page 10: Mount The Unit And Attach It To The Cabinet
2.4.2 Mount the Unit and Attach It to the Cabinet 1. Lift the unit onto the door, placing the two mounting holes on the top end, over the two screws attached to the door and bracket. Place nuts on the screws to hold the unit in place. 2. -
Page 11: Power Connections
OWER Connect the power cords to separate power sources (as specified in Specifications on page 9), to keep the XDA operating if there is a power failure on one circuit. Route the power cords under or over the cabinet as needed to the nearest available receptacles. If only one power source is available, connect both power cords to this source. -
Page 12: Operation & Maintenance
The XDA will continue to operate as long as either of the two power sources is available. The Liebert XDA is essentially maintenance-free. An occasional vacu- uming at the same time other cabinet equipment is cleaned is ade- quate. -
Page 13: Specifications
PECIFICATIONS Nominal Capacity Dimensions W x D x H, in (mm) Weight, lbs (kg) Electrical Specifications Amp Draw 1000 CFM @ 60Hz 8 x 2.25 x 56 (203.2 x 57.2 x 1422.4) 25 (11.3) 120V-1-50/60Hz 230V-1-50/60Hz 1.5 A @ 120V 0.8 A @ 230V... - Page 16 © 2006 Liebert Corporation All rights reserved throughout the world. Specifications subject to change without notice. ® Liebert and the Liebert logo are registered trademarks of Liebert Corporation. All names referred to are trademarks or registered trademarks of their respective owners. SL-16610_REV2_08-06 Emerson Network Power.
Need help?
Do you have a question about the Air Flow Enhander XDA and is the answer not in the manual?
Questions and answers