AC outlet and as doing so may result in fire or electric shock. contact your nearest Myers dealer. Make no further attempt to operate the unit in this condition as this Use the unit only with the voltage specified on the may cause fire or electric shock.
Page 4
When removing the power cord, be sure to hold its plug to pull. Contact your Myers dealer as to the cleaning. If dust is allowed to accumulate in the unit over a long Do not block the ventilation slots in the unit's cover.
2. GENERAL DESCRIPTION The Mixer Zone Amplifier series is equiped with priority function. They are designed to suit all PA system application in schools home offices and stores. 3. FEATURES 5 zone output and 5 zone separate volume control Built-in siren.
NOMENCLATURE AND FUNCTIONS 4.2 REAR PANEL 38 37 OUTPUT ZONE 5 ZONE 4 ZONE 3 ZONE 2 ZONE 1 REMOTE MIC REMOTE REMOTE MIC 100V 100V 100V 100V 100V 100V GAIN VOLUME 2 TONE 4 TONE ON OFF ON OFF ON OFF ON OFF PRIORITY...
Page 8
NOMENCLATURE AND FUNCTIONS Pin 1: Remote amplifier input signal hot(+) Pin 2: Remote amplifier input signal cold(-) Pin 3: Signal ground Pin 4: Remote control 1(Speaker 1) Pin 5: Remote control 2(Speaker 2) Pin 6: Remote control 3(Speaker 3) Pin 7: Remote control 4(Speaker 4) Pin 8: Remote control 5(Speaker 5) Pin 9: Remote control ground Pin 10: DC +24V...
5. OPERATING CONNECTING SPEAKERS Before connecting speakers, disconnect the AC power cable. Note the proper connecting terminals as shown Below. Make certain that the total impe- dance is not less than the rated impedance indicated. CONNECTING HIGH-VOLTAGE DISTRIBUTED SPEAKER SYSTEMS When connecting speaker system in parallel, you can connect speakers with a total rated input of up to 100W.
Need help?
Do you have a question about the MI-120S and is the answer not in the manual?
Questions and answers