Table of Contents
Advertisement
User's Information
Rotate door to closed position. Ensure ends of door
overlap cabinet. (See detail)
Rotate latches to secure door.
4. Ensure the power cord is plugged into the air clean-
er.
5. Press the POWER button
cleaner.
Fig. 15
The whole house air cleaner can be connected in one
of two modes of operation; either a 24 V mode or a
communicating mode. To know how the whole house air
cleaner is set up, reference Figure 15 to find the amber
light.
A steady amber light indicates that the unit is wired in
the 24 V mode.
A blinking amber light indicates that the unit is wired in
the communicating mode.
No light present means that the unit is not connected.
8
Cabinet Edge
Fig. 13
Fig. 14
to turn on the air
Power Button
Amber Light
Plug Power Cord
in here
Numbers in [brackets] are for 50 Hz international systems.
NOTE: Once you press the POWER button, the first
LED will be on and it will start flashing after the
first 10 [12] minutes of indoor fan operation. This
is normal operation.
Alternate Cleaning option for homeowners with 200
or 200-1 COLLECTION CELLS ONLY
Vacuuming the PRE-FILTER and COLLECTION CELLS
restores them to a high efficiency. However, some
environmental conditions, like tobacco smoke, cause the
COLLECTION CELLS to need to be washed with water.
Washing the COLLECTION CELLS is acceptable
ONLY if the COLLECTION CELL has a "200/200-1"
embossed or written on the frame in the vicinity of the
manufacturing part number:
Carefully review BOTH of the COLLECTION CELLS
for the "200/200-1" mark. If the "200/200-1" mark is
visible on BOTH COLLECTION CELLS, they may be
washed. If the "200/200-1" mark is NOT visible, the
COLLECTION CELLS cannot be washed.
CAUTION
L
!
Washing COLLECTION CELLS that do NOT have the
"200/200-1" mark on them can result in degradation
of the air cleaner system. Failure to follow
instructions could result in property damages.
1.
If the COLLECTION CELLS do have the "200/200-
1" mark on them, they may be washed using a low
pressure water spray, such as a sink sprayer or gar-
den hose. Residue like tobacco smoke may require
warm water to be removed.
• Do NOT use soap or detergent in cleaning the
COLLECTION CELLS.
• Do NOT immerse the COLLECTION CELLS
completely in water.
• Do NOT place the COLLECTION CELLS into a
dishwasher to clean.
• ALLOW THE COLLECTION CELLS TO DRY
THOROUGHLY BEFORE INSTALLING.
Fig. 16
12-5045-10
Hide quick links:
Advertisement
Table of Contents
