Repeat Playback; Programmed Playback - Electrohome WINSTON Instruction Manual

REPEAT PLAYBACK

1. To repeat a single track, press the REPEAT button once, the repeat LED indicator will blink, press the
SKIP REV button or SKIP FWD button to select the desired track, press the PLAY/PAUSE button to begin
repeat playback of the selected track.
2. To repeat all of the tracks on a disc continuously, press the REPEAT button twice, the repeat LED
indicator will light solid. Press the PLAY/PAUSE button to begin repeat playback of the entire disc.
3. To cancel repeat playback, press the REPEAT button until the repeat LED indicator turns off.
4. Repeat playback is also canceled by pressing the STOP button, or setting the AM-FM-PH-CD-AUX switch
the to the AM, FM or PH position.

PROGRAMMED PLAYBACK

The CD player in this unit has a 20 - track programmable memory that allows you to program the disc to
playback songs in any desired order.
1. While in STOP mode of CD playback, press the PROGRAM button; "0" will appear in the display and the
program LED indicator will blink.
2. Select the first track to be programmed using the SKIP REV or SKIP FWD button.
3. Press the PROGRAM button again to confirm it, when the desired track appears in the display. Repeats
steps 2 and 3 to program up to 20 tracks. You may program the same track more than once.
4. Press the PLAY/PAUSE button to begin programmed playback; the program LED indicator will blink.
Player will begin with the first track you programmed and will continue until the last programmed
track has played.
5. Press the SKIP REV or SKIP FW button to select a specific track in the programmed tracks. After the last
track has played, the player will stop. However, the program sequence remains in the memory. The
program indicator will turn off.
6. To repeat the programmed sequence, press the PROGRAM button and then press the PLAY/PAUSE
button. The programmed sequence may be cancelled by pressing the STOP button while in stop mode.
• Programming is the ability to pre-select the order in which a series of tracks will be played
• The CD player will stop after all programmed tracks have been played or the STOP button is pressed
• "--" and the program indicator will blink when you have programmed 20 tracks
• During PROGRAMMED playback, press REPEAT button twice to activate repeat all feature.
The REPEAT inidcator will light and all tracks in your programmed sequence will be repeated
continuously. To cancel programmed repeat playback press the STOP button until both the program
and repeat LED indicator go out
OPERATION
- 10 -