Single Ip Address Operation Using Nat - NETGEAR FWG114P Reference Manual

Reference Manual for the ProSafe Wireless 802.11g Firewall/Print Server Model FWG114P

Single IP Address Operation Using NAT

In the past, if multiple PCs on a LAN needed to access the Internet simultaneously, you had to
obtain a range of IP addresses from the ISP. This type of Internet account is more costly than a
single-address account typically used by a single user with a modem, rather than a router. The
FWG114P Wireless Firewall/Print Server employs an address-sharing method called Network
Address Translation (NAT). This method allows several networked PCs to share an Internet
account using only a single IP address, which may be statically or dynamically assigned by your
ISP.
The router accomplishes this address sharing by translating the internal LAN IP addresses to a
single address that is globally unique on the Internet. The internal LAN IP addresses can be either
private addresses or registered addresses. For more information about IP address translation, refer
to RFC 1631, The IP Network Address Translator (NAT).
The following figure illustrates a single IP address operation.
192.168.0.2
192.168.0.3
192.168.0.4
192.168.0.5
Figure 10-3: Single IP Address Operation Using NAT
B-8
Private IP addresses
assigned by user
192.168.0.1 172.21.15.105
December 2003, M-10177-01
IP addresses
assigned by ISP
Internet
7786EA
Network, Routing, and Firewall Basics