Panasonic AW-HE130WP Installation Instructions Manual page 10

How to install and connect the unit (continued)
6.
Connect the rear panel connectors.
Anchor the AC adaptor cable in place using the cable clamp.
When three coaxial cables are to be connected, connect coaxial cable [2] first.
z How to secure the AC adaptor cable
A Loosely secure the cable clamp.
Cable clamp
7. Attach the cable cover.
• Fit the two tabs on the cable cover into the square mounting hole at either side of the rear panel.
• Secure the cable cover using the screw (M3 x 25 mm) provided.
Screw
Clamping torque
diameter
M3 0.78 N · m (8 kgf · cm)
<NOTE>
• Engage the tabs on the cable cover so they fit into place perfectly, and check that the cover is not rickety.
• When attaching an anti-theft wire, do so after attaching the cable cover.
10
Loosely secure the cable clamp
in the area shown above.
LAN cable
RS‑232C cable
Coaxial cable [3]
Coaxial cable [2]
Coaxial cable [1]
HDMI cable
AC adaptor cable
Screw for cable cover (M3 screw)
(with flat washer, spring washer)
B Fasten the cable clamp.
Strap part
Take hold of the strap part, slide
the cable clamp until it stops
moving, and then secure it tightly.
LAN cable
RS‑232C cable