Advertisement
TROUBLESHOOTING
Always turn down the volume to a low level or turn off all equipment before checking.
PROBLEM
No sound.
Sound in one channel only.
Hum or Buzz noise.
SPECIFICATIONS
MM SPECIFICATIONS
Input impedance (R and C)
Gain at 1 kHz
Input sensitivity (ref. 200 mV output)
Signal-to-noise ratio
Input overload (20Hz/1kHz/20kHz)
Total Harmonic Distortion
RIAA response accuracy
Specifications are subject to change without notice.
For updated documentation and features, please check out
All rights reserved. NAD and the NAD logo are trademarks of NAD Electronics International, a division of Lenbrook Industries Limited.
No part of this publication may be reproduced, stored or transmitted in any form without the written permission of NAD Electronics International.
While every effort has been made to ensure the contents are accurate at the time of publication, features and specifications may be subject to change without prior notice.
POSSIBLE CAUSE
• (LED is not illuminated) Power Supply not connected
to either NAD PP 2e or mains socket.
• (LED is illuminated) Wrong input on amplifier/receiver
selected.
• Plugs from turntable and/or lead from NAD PP 2e to
amplifier/receiver sockets not property fitted.
• Plugs from turntable and/or lead from NAD PP 2e to
amplifier/receiver sockets not property fitted.
• No connection from turntable to ground.
• Earth loop present.
• Interference from nearby equipment
47 kohms + 200 pF
34 dB
2.5 mV
80 dB
(A-weighted, with cartridge connected)
67 dB
(Unweighted, with cartridge connected)
10/102/950 mV
<0.03%
±0.3 dB
www.NADelectronics.com
©2015 NAD ELECTRONICS INTERNATIONAL, A DIVISION OF LENBROOK INDUSTRIES LIMITED
PP2E_ENG_OM_V03 - 04/15
• Plug in dedicated Power Supply.
• Select input to which NAD PP 2e is connected.
• Check to see if the MM/MC selector switch is set
correctly for your type of turntable cartridge (make
sure to turn off all equipment beforehand).
• Check all connections (make sure to turn off all
equipment beforehand).
• Check all connections (make sure to turn off all
equipment beforehand).
• Connect the turntable's earth (GND) lead directly to
a ground connection or to NAD PP 2e's thumb screw
terminal "GND" which provides the grounding.
• If connected, disconnect turntable's earth lead from
amplifier/receiver.
• Move NAD PP 3i and cables further away from other
equipment.
MC SPECIFICATIONS
Input impedance (R and C)
Gain at 1 kHz
Input sensitivity (ref. 200 mV output)
Signal-to-noise ratio
Input overload (20Hz/1kHz/20kHz)
Total Harmonic Distortion
RIAA response accuracy
GENERAL SPECIFICATIONS
AC supply
Unit dimensions (W x H x D)
for the latest information about PP 2e.
POSSIBLE SOLUTION
100 ohms + 180 pF
58 dB
0.3 mV
78 dB
(A-weighted, with cartridge connected)
67 dB
(Unweighted, with cartridge connected)
0.8/9/84mV
<0.03% (20 Hz – 20 kHz at 3V output)
±0.3 dB
External 23.5V DC
135 x 43 x 72 mm
5.3 x 1.7 x 2.8 inches
Advertisement
