Uniform Wares M40 User Instructions

User instructions
Setting the time
1. Adjust the watch crown (A), situated on the side of
the case at the 3 o'clock mark, out from the Operating
Position to Set Position 2 (P2), where the crown is fully
extended at the second adjustment click. You will notice
the second hand stops ticking.
2. Turn the crown clockwise to the desired time.
DO NOT turn the crown anti-clockwise.
3. When the time is set, push the crown back to the
Operating Position and the second hand will resume.
Setting the date
1. Adjust the watch crown out from the Operating
Position to Set Position 1 (P1), where the crown is half
extended at the first adjustment click.
2. In Set Position 1 (P1) the watch will continue ticking
during adjustment. Turn the crown clockwise until
the correct date is displayed.
3. When the date is set, push the crown back to the
Operating Position.
Please note: The date should be set before 12 noon
so that the calendar indicator changes in sync at
twelve midnight and not twelve noon.
Please note: Whilst the crown is in either Set Position
1 or 2 the watch is not moisture resistant.
Watch care
Your Uniform Wares watch requires a certain amount of
care. The following guidelines will enable you to ensure
its reliability and protect its appearance over time.
Cleaning
Please use a clean, lint-free cloth with warm water
or, if required, a mild detergent diluted in water to
remove any dirt from the case. To clean the lens use
A
a clean chamois cloth. Avoid submerging the watch
P1–2
case in water.
Battery
Your watch's power source is a Swiss-made Renata cell
which has an estimated lifespan of 60 months. When
your battery requires replacing, please refer to the
Uniform Wares website www.uniformwares.com/service
for information on battery replacement.
Water resistance
This watch is designed to withstand everyday use and
has a 5ATM water resistance rating. Exposure to high
humidity and light rain showers is acceptable. However,
you should avoid wearing the watch whilst showering,
swimming, diving or during any other activity where
it may be subjected to abnormal water pressures or
environments where abnormal heat and moisture are
present (e.g. saunas or hot tubs). This combination
may have a negative effect on the seals and gaskets
of the watch.
Condensation
If your watch experiences a sudden change in
temperature or pressure, a slight condensation may
appear under the sapphire glass. This mist should
disappear by itself and will not affect the functioning of
your watch. If the condensation persists, please contact
www.uniformwares.com/service.
Guarantee
This Uniform Wares watch is guaranteed against
defects in materials and workmanship under normal use
for a period of two years from the date of retail purchase
by the original end-user purchaser. If a hardware defect
arises within the warranty period, please refer to the
Uniform Wares website www.uniformwares.com/
service for information on the repair procedure for
your particular watch.