Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Navison audio NVS-003G
Summary of Contents for Navison audio NVS-003G
- Page 1 Navisonaudio T h e n a t u r a l s o u n d NVS - 003G...
- Page 3 NOTE: Before installing your new power amplifiers, please read this manual carefully as it will inform you of the product specifications, proper installation and operation procedures. Included in this manual are guidelines on how to properly install the tubes. NVS-003G Owner’s Manual...
-
Page 4: Specifications
: Oil paper CAPACITORS : IEC standard plug, detachable cord AC POWER CORD : 10 minutes WARM-UP TIME : 100 hours of music playing time BREAK-IN PERIOD Specifications are subject to change or improvement without notice or obligation. NVS-003G Owner’s Manual... -
Page 5: Top Panel Features
8 ohm speaker connections. : Never replace with any other value than 15 AMP SLOW BLOW FUSE AC POWER FUSE with 115 Volt Rating. : Never replace with any other fuse than - amp FAST BLOW FUSE! TUBE FUSE NVS-003G Owner’s Manual... -
Page 6: Installation
Volts AC at 50/60Hz (Export units 230 Volts AC at 50/60Hz, by market). Speaker Cables The speaker cables from the output posts of the NVS-003G to the speaker system can be any length that your setup requires. Select speaker cables of sufficient size to preserve the outstanding performance capabilities and sound quality of your new power amplifiers. -
Page 7: Interconnect Cables
RCA. The input interconnect cables from the output of the preamplifier can be any length your installation requires. A shielded high quality interconnect cable is important to reduce chances for hum or interference. Ask your Authorized Navison audio dealer for advice. Operation Your new amplifier is ready for operation after the speaker cables, interconnect cables and the tubes have been installed. - Page 8 6C33C-B output. WARNING! Make no attempt to put the NVS-003G in service with the chassis open! Contact with the high voltages found inside the chassis can be fatal! Remove the AC power plug from the wall and allow 30 minutes for thehigh voltage capacitors to discharge through bleeder resistors beforeattempting to change the tubes or to clean the inside the amplifier.
-
Page 9: Obtaining Warranty Service
Units which have been modified, altered, or improperly repaired by anyone not specifically authorized by Navison audio design, Inc. c) Units not purchased from an authorized Navison audio dealer in the United States for use in the United States. - Page 10 • 1-877-NAV-IZON or (628-4966) Service If your Navison audio component requires service, repack it using the original box and packing material and ship to the Service Department address above. Boxes and packing materials can be obtained from our service department for a nominal charge, if you no longer have yours.
- Page 12 Thank you for selecting the NAVISON AUDIO products for your audio system. www.navisonaudio.com...