Hipstreet HS-BT102-BK User Manual

Thank you for purchasing a Hip Street product and we hope you enjoy
using it. Please visit our website at www.hipstreetonline.com.

Preface

Kindly read and retain all the operating instructions before operating
the unit. We cannot assume any liability that may arise out of improper
operation or incidental/accidental damages. The contents of this user
manual are subject to change based on newer developments.

Introduction

The Hip Street Bluetooth headset allows you the freedom to make
and receive calls while on the move or in the office. You can connect
the headset to a compatible phone that supports Bluetooth wireless
technology.

Bluetooth wireless technology

Bluetooth wireless technology makes it possible to connect compatible
communication devices without using cables. A Bluetooth connection
does not require that the phone and the headset be in line of sight, but
both devices should be within 10 meters of each other.

Overview

The figure below shows the main parts of the headset:
Answer/End (Talk) key
1.
Indicator light (Power/Pairing Mode)
2.
Volume keys
3.
Microphone
4.
Earphone
5.
Charging connector
6.
Before you can start using the headset, you must fully charge the
battery.

Charging the battery

This device has an internal, non-removable, rechargeable battery. Do not
attempt to remove the battery from the device as you may damage the
device and void the warranty.
Connect the charging cable to the headset.
1.
Connect the other end of the charging cable to an available
2.
USB port on your computer or laptop. (The computer or laptop
must be powered on to change the headset.) The red indicator
light on the headset is displayed during charging. If the charging
light does not come on, disconnect the charging cable and retry.
Full charge may take up to 1.5 hours.
When the battery is fully charged, the red indicator light on the
3.
headset will turn off.
Disconnect the charging cable from the headset and computer
4.
or laptop.
The fully charged battery will power the headset for up to 6 hours of talk
time or up to 200 hours of standby time. Please note these values may
vary depending on the various usage scenarios and with different mobile
phones. When the battery is running low on power, the red indicator light
will start to flash.

Turn the headset ON / OFF

To switch the headset on, press and hold the Answer/End key
1.
for 3 seconds. The blue indicator light will start to blink.
To switch the headset off, press and hold the Answer/End
2.
key for 3 seconds until the headset beeps 2 times and the red
indicator light displays briefly.

Pairing the headset

Make sure your headset is turned OFF with no lights blinking.
1.
Press the Answer (Talk) key for 7 seconds or until the blue and
2.
red lights blink alternately.
Activate the Bluetooth feature on the mobile phone or Bluetooth
3.
compatible device and set it to search for devices (See the user
guide of your mobile phone or device for instructions).
Select the headset "HIP STREET" from the list of found
4.
devices.
Enter the pass code "0000" to pair the headset to your phone or
5.
Bluetooth compatible device.
If the pairing is successful, the headset's blue light will flash 3
6.