Summary of Contents for QFX CR-91NOA
- Page 1 FM/AM/WB Dual Tuners All Hazard Weather Alert Clock Radio Operating Instructions CR-91NOA Printed in China...
-
Page 2: Installing The Battery
Before You Begin Install the batteries with correct polarity and Thank you for choosing the QFX All Hazard then close the lid. Weather Alert Device! It will give you many During a power interruption, the display will... - Page 3 Knowing When to Replace the Battery Warning Battery When the unit will be left unplugged for a long time, To check battery power, unplug the AC remove the battery to avoid undue battery power cord from the wall outlet. If both the discharge and damage to the unit from battery Alert indicator is flashing slower , replace leakage.
-
Page 4: Setting The Clock
--------------------------------- --------------------------------- Setting the Clock Playing the Radio Plug in the unit. The display will flash In standby mode, press ON/OFF to turn “12:00” (a.m.) on the radio and adjust VOLUME +/-. Or, press SET over 1 seconds in standby Press BAND and tune in a station using mode. -
Page 5: Setting The Alarm
improve the reception. Tune on the radio, press BAND to switch to FM or AM, press SET over 5 seconds AM: Rotate the unit horizontally for optimum until the unit start scanning the frequency. reception. A ferrite bar antenna is built into the unit. -
Page 6: Setting The Sleep Timer
station (AM/FM/WB) just before the alarm preset radio. --------------------------------- time. Setting the Sleep • To check the preset time, press AL1/AL2 at the Timer standby mode. --------------------------------- Enjoy falling asleep to the radio using the Operations in Alarming built-in sleep timer that shuts off the radio During alarming, you could press ON/OFF automatically. -
Page 7: Specifications
play that particular weather band channel at maximum volume for 15 minute. The alert indicator flashes every 2 seconds while it is at the monitoring mode. If the unit is activated by the 1050Hz tone alert, the alert indicator and the WB indicator will flash alternatively. - Page 8 WB: CH1 – CH7 (162.400/162.425/162.450/162.475/162.500/162.525/162.550MHz) Speaker: Approx. 4.8 cm (1 9 ⁄10 inches) dia., 16 ohmÙ Power output: 100 mW (at 10 % harmonic distortion) Power requirements: 120 V AC, 60 Hz For the power back-up function: 3 V DC, two AAA batteries Dimensions: Approx.