Summary of Contents for MTS Systems 3G CDMA-450
- Page 1 Version: 01, December 2008 Install & Data Connection AXESSTEL MV110 for Mac OS X МТS Connect 3G CDMA-450...
-
Page 2: Table Of Contents
Table of Contents Introduction ......................3 Initial conditions for operating MTS Connect Service ........3 Driver Installation ....................4 Step 1 ........................4 Step 2 ........................5 Step 3 ........................6 Step 4 ........................7 Step 5 ........................8 Step 6 ........................9 Step 7 ........................10 Step 8 ........................11 Step 9 ........................12... -
Page 3: Introduction
Introduction This manual describes specifics of arranging subscription to MTS Connect Service (CDMA-450) on a PC/Notebook with the installed operational system (ОS): Mac OS X 10.4 (TIGER), Mac OS X 10.5 (LEOPARD) using terminal equipment AXESSTEL MV110. See AXESSTEL MV110 Installation and Connection Manual for Windows for details related to terminal equipment operation (operation conditions, completeness of set, intended purpose of indicators), and recommendations how to improve network connection quality, safety recommendations and typical questions. -
Page 4: Driver Installation
Driver Installation — Mac OS 10.4.x (TIGER) or above; — Mac OS 10.5.x (LEOPARD) or above. Shut down any programs that are running on your computer at this time. DO NOT CONNECT THE MODEM DURING INSTALLATION OF USB DRIVER. Step 1: Click AxesstelMSPDriver to install USB driver. -
Page 5: Step
Step 2: Click “Continue” to continue. -
Page 6: Step
Step 3: Select destination where you want to install driver and click “Install”. -
Page 7: Step
Step 4: Click “Restart” to complete installation process. Note. Your PC will be restarted to complete driver installation. After restarting, connect the device with your computer. -
Page 8: Step
Step 5: Go to System Preference and run Network in “Internet & Network” group. -
Page 9: Step
Step 6: Select Axesstel Modem Port and click “Advanced”. -
Page 10: Step
Step 7: Select Other in Vendor and Axesstel modem script in Model column. -
Page 11: Step
Step 8: Click “OK” to apply current configuration. -
Page 12: Step
Step 9: Set the following parameters of authorization: Telephone number: #777 Account name: mobile Password: internet Step Click “Connect” to connect to network. Caution. Removal of modem from PC prior to disconnecting modem from network is not allowed. There can be a problem if modem is removed from PC before performing disconnection. - Page 13 www.mts.com.ua wap.mts.com.ua...