Table of Contents
Advertisement
Mounting a Detector
♦
Select the installation location.
♦
Remove locking pin securing the
mounting bracket to the unit (see
Figure 7).
♦
Remove the mounting bracket
from the unit by rotating it
counterclockwise.
♦
Use the bracket as a template for
marking the mounting holes
♦
Using an appropriate drill, drill two
holes at the marks and insert
anchors.
♦
Using screws (supplied) attach the
bracket to the wall as in Figure 7.
♦
Line up the side slot of the bracket
and the detector. Push the
detector onto the mounting
bracket and turn it clockwise to fix
it into place.
Insert the locking pin in order to
secure the mounting bracket to
the detector (see figure 7).
♦
Pull the detector outward to make
sure it is securely attached to the
mounting bracket.
WARNING:
This detector is not suitable for installation in a
hazardous location, as defined in the national
electrical code. Do not use detector in an
outlet controlled by a wall switch.
Deleting a Smoke Detector
To delete a smoke detector from the system:
1.
Set the system to Delete mode.
a.
Go to the main menu and select [9]>[1]>[1] (Programming > Devices
> Zones).
b.
Select a zone and press '√'
c.
Press >12 >3.
2.
Open the detector and take out the battery.
3.
Press the tamper switch. While the tamper switch is being pressed insert
the battery. Within five seconds open the tamper and close it again
2-Way Wireless Supervised Photoelectric Smoke Detector
Locking Pin
Bracket
Figure 7: Smoke Detector Installation
Battery Compartment
Tamper
Figure 8: Batteries Compartment/Tamper
Detector
Screws
9
Advertisement
Table of Contents
