Summary of Contents for TAG HDIT-2000I-DP
- Page 1 HDIT-2000I-DP HDIT-108R Reference Manual 22355 TAG WAY Dulles, VA 20166-9310 Technical Support: (877) TAG-TECH +1 (703) 406-4516 tag.com...
-
Page 2: Telephone Numbers
NT 4.0 Server Load Instructions Contact Information: ® Steps for loading Windows NT Server 4.0 on TAG 2U RAID Servers 1) Boot the computer with a bootable floppy (ie Windows 95 startup disk). (disk must contain Command.Com and Fdisk). 2) Execute Fdisk and create a 4GB partition on the Hard Drive. - Page 3 Figure 21 ©2001 Technology Advancement Group, Inc. All rights reserved. Technology Advancement Group, TAG, HDIT, High-Density Information Technology, and the TAG Ball graphic are trademarks or registered trademarks of Technology Advancement Group, Inc. This manual and/or its contents may not be duplicated without written permission of Technol- Figure 22 ogy Advancement Group, Inc.
- Page 4 TAG’s R&D department have labored over countless CAD quickly as possible. Go to Page 4 for detailed instructions on the replacement of a drawings to fully utilize every square inch of space.
- Page 5 2000I-DP Features HDIT-108R Rear Panel The heart of the system is the 2000I-DP. Dual 850MHz Pentium III processors and 512MB of RAM makes this low-profile server a powerful one. It is equipped with a DAT backup device, a ZIP Drive, LS-120 Drive, Floppy Drive, CD-ROM, and a The HDIT-108R connects to the 2000I-DP with the connectors located in the PC Card Reader.
-
Page 6: Power Supply Specifications
System Rear Panel - Power Supplies 2000I-DP Power-Up Procedures Situated on the back of both the 2000I-DP and the HDIT-108R are Auto- To correctly power-up the 2000I-DP, the following procedures must be Switching 115/230VAC power supplies, (See Figure 16). FOr each system, the performed in the order listed below: system main power switch is located just beneath the power supply’s cooling fan. - Page 7 The connectors for all of the external peripherals are located on the left side the front panel. TAG has configured the reader with SCSI #3. Refer to page 10 for all of the rear panel of the 2000I-DP, (See Figures 14 & 15). When connecting SCSI IDs.
- Page 8 The HDIT-108R is equipped with four hot-swap 18GB Ultra 2 Wide SCSI LVD the CD is read. hard drives, (See Figures 10 & 11). TAG has configured the removable drives with the following SCSI ID’s: The bottom left drive, Drive 1, is SCSI ID #0 and the top left drive, Drive 2, is SCSI ID # 1 the bottom right drive, Drive 3, is SCSI ID #2 and the top right drive, Drive 4, is SCSI ID # 3.
Need help?
Do you have a question about the HDIT-2000I-DP and is the answer not in the manual?
Questions and answers