Realtone RT62 User Manual

Model: RT62
Stereophonic Headphones
with On-Ear Volume Control
Using Your realtone Headphones
There are "L" and "R" markings on the headphones. When
worn properly the headphone cable will be on your left side
and the volume control will be on your right side. The two ear
cups may be adjusted up or down for most comfortable fit.
Connect the headphone plug to the headphone jack of your
music player. Be sure that the plug is fully inserted into the
jack. If the plug is not fully inserted you may only hear sound
from one side of the headphones.
If you are using this headphone with an older stereo receiver that has a larger size
headphone jack, attach the supplied 6.3mm headphone plug adapter to the 3.5mm
headphone plug.
To protect your hearing, always start listening with the headphone Volume Control set
to a low level and gradually increase the volume to a comfortable listening level.
Note: You may have to adjust the volume control on your music player as well as the
built-in Volume Control on your headphones to find the most satisfactory sound level. If
one control is set too low and the other is set too high, the sound may be distorted. Try
setting the volume control on your music player halfway between the Min and Max
settings, and then use the built-in Volume Control on your realtone headphones to
make final adjustments.
IMPORTANT! Listening at high volume for long periods of time can result in long-term
hearing damage. For your safety, do not use headphones if they would prevent you
from hearing warning sounds, such as while driving a car or motorcycle, riding a bike,
etc. Remember that on-the-ear style headphones such as the RT62 may block outside
noise, including warning sounds. Always be aware of your surroundings and do not use
these headphones in situations that require you to hear warning sounds.
On-Ear Volume Control