Dynex DX-CSP215 Quick Setup Manual

Package contents

• Dynex speakers (2)
• Paint plugs (2)
• Grills (2)
• Template (1)
• Quick Setup Guide
Tools you will need:
• Pencil
• Keyhole or drywall saw
• Phillips screwdriver
• Sturdy wire or coat hanger
• Wire strippers
• Gloves (optional for insulation)
• Drill
• ¼- to ½-inch drill bit (for drilling test hole)
• Stud finder
Before using your new product, please read these instructions to prevent any damage.
Mounting tips
For stereo sound
Mount the speakers
6-10 feet apart.
Each speaker
should be the same
distance from the
listening area.
For home theater surround sound
Ceiling mount instructions
1 Determine where you want to mount the speakers. The speakers must be
mounted in areas where there are no obstructions like studs (joists). Use
a stud finder to locate the studs.
Notes:
• Make sure that your speaker wires are long enough to run from the speakers
to your audio equipment.
• The wires must be UL or CL rated to ensure your safety and to meet building
code compliance.
6.5" In-Ceiling Speaker Pair |
2 Position the cardboard mounting template on
the ceiling where you want to mount a
speaker, then trace around the template.
3 Drill a small hole in the center of the template
outline you drew on the ceiling.
4 Bend a piece of coat hanger wire, then insert
the wire into the hole. Slowly rotate the wire
to check for any obstructions. If you find an
obstruction, patch the hole and find a new
location for the speaker.
Mount the
speakers 6-10 feet
apart and 3-6 feet
5 Using a keyhole or drywall saw, carefully cut
behind the
the ceiling section you outlined, then remove
listening area.
the section.
6 Run the wires from the speaker outputs on
your audio equipment to the hole created for
your speaker. Allow a few extra feet of wire so
you will have enough wire to easily connect
the speaker before mounting it to the ceiling.
Warning: Make sure your audio equipment is
disconnected from power before running the
wires through the walls or ceiling.
Note: Use high-quality wire such as 16 gauge UL
or CL rated speaker wire.
Quick Setup Guide
DX-CSP215