Waterfall Audio HF2-250 User Manual

User's Manual
Subwoofer
We thank you very much for purchasing a Waterfall High Force Subwoofer. Our deliberate choice for aesthetics and
performance is constantly guiding our research and development towards innovative technologies. In order to achieve the
best performance with your Home Cinema system, we recommend you read carefully the following set up instructions.
A) Functions and set up
WARNING :
Before connecting your sub to the mains for the first time check that the value indicated above the (N°3) switch is suitable for your
country. Changing the fuse : In the event of complete failure, first disconnect the power cable from the mains, then check the mains
fuse. When replacing the fuse, only use a fuse which is absolutely identical to the original one. If this does not solve the problem,
contact your dealer.
• Only the subwoofer is to be connected to the mains supply..
• Before proceeding with any connection, make sure that all your equipment is switched off.
• Before switching it on, please ensure that the "level" button (N°4) is on minimum.
• Your Waterfall Speakers are to be directly connected to the speaker output socket on your amplifier or AV / Processor. Never plug
your speakers to the mains
• Also ensure that the polarities are correct : + (red) and - (black).
• Do not expose this product to heat and humidity.
8
9
5
7
11
12
Your HF2-250 Subwoofer is equipped with a wide range of connection options for Hi Fi or Audi Video, Home Cinema.
The subwoofer needs to be connected to the mains with the plug supplied, Switch N°3 must be on "ON" position and the N°8 switch on
"ON" position.
HF2-250
In order to get the best acoustical results, HF2-250 should be
placed in a corner of the room.
6 4
Control panel
10
Main power
switch
(on - off)
3
Fuse
2
1
Mains cord
(supplied)
www.waterfallaudio.com
Mains plug (included)
1
Fuse box
2
Main power switch (on - off)
3
Level : Volume adjustment of the integrated amplifier.
4
Phase switch : Allows to adjust phase on 0° or 180°
5
Freq : Adjustment of the frequency cut off, from 40 to
6
150Hz.
Standby LED indicates unit in standby mode (will flash
7
on/off if problem is detected)
Standby or On (auto mode)
8
Switch for the active filter of the sub. 24dB/oct -
9
12dB/oct - LFE (no low pass filter)
DO NOT CHANGE.
Factory settings.
10
Low Level Input left & right
11
High level Input left & right
12
WARNING : double check that polarities
+ & - are correct