Page 1
Nokia 3720 Classic RM-518 Service Manual Level 1&2 SERVICE MANUAL Level 1&2 Transceiver characteristics Band: RM-518: GSM/EDGE 900/1800/1900 Display: QVGA display (320 x 240 pixels) 2.2” colour display, Up to 16.7 M colours Camera: 2 Mpix with full screen viewfinder, 4 x digital...
25.6.2009 First approved version The purpose of this document is to help NOKIA service levels 1 and 2 workshop technicians to carry out service to NOKIA products. This Service Manual is to be used only by authorized NOKIA service suppliers, and the content of it is confidential. Please note that NOKIA provides also other guidance documents (e.g.
Nokia operates a policy of continuous development. Nokia reserves the right to make changes and improvements to any of the products described in this document without prior notice. Under no circumstances shall Nokia be responsible for any loss of data or income or any special, incidental, consequential or indirect damages howsoever caused.
Nokia 3720 Classic RM-518 Service Manual Level 1&2 3. WARNINGS AND CAUTIONS Please refer to the phone’s user guide for instructions relating to operation, care and maintenance including important safety information. Note also the following: 3.1 Warnings 1. CARE MUST BE TAKEN ON INSTALLATION IN VEHICLES FITTED WITH ELECTRONIC ENGINE MANAGEMENT SYSTEMS AND ANTI–SKID BRAKING SYSTEMS.
Nokia 3720 Classic RM-518 Service Manual Level 1&2 4. ESD PROTECTION Nokia requires that service points have sufficient ESD protection (against static electricity) when servicing the phone. Any product of which the covers are removed must be handled with ESD protection.
Nokia 3720 Classic RM-518 Service Manual Level 1&2 5. CARE AND MAINTENANCE This product is of superior design and craftsmanship and should be treated with care. The suggestions below will help you to fulfil any warranty obligations and to enjoy this product for many years.
Nokia 3720 Classic RM-518 Service Manual Level 1&2 6. BATTERY INFORMATION Note: A new battery’s full performance is achieved only after two or three complete charge and discharge cycles! The battery can be charged and discharged hundreds of times but it will eventually wear out.
Nokia 3720 Classic RM-518 Service Manual Level 1&2 10. DISASSEMBLY INSTRUCTIONS 10. DISASSEMBLY INSTRUCTIONS Note: All devices with damage caused by liquid and/or intrusion need to be Note: All devices with damage caused by liquid and/or intrusion need to be sent to Level 3 for repair.
Page 13
Nokia 3720 Classic RM-518 Service Manual Level 1&2 7) Release the A-COVER ASSY with SRT-6. Start 8) Slide SRT-6 towards the top side… from the bottom, under the rubber sealing. 9) …under the rubber sealing. 10) Do the same procedure on the opposite side of the A-COVER ASSY.
Page 14
Nokia 3720 Classic RM-518 Service Manual Level 1&2 13) Remove the KEYPAD. 14) Protect the LCD with protection foil and unscrew the six screws with Torx 6+. 15) Remove the PWB including the LCD and UI SHIELDING LID ASSY. 16) Release the snaps of the UI SHIELDING LID 17) Remove the UI SHIELDING LID ASSY.
Page 15
Nokia 3720 Classic RM-518 Service Manual Level 1&2 18) Flip open the LCD… 19) …and remove the FLEX SHIELDING LID ASSY using dental tool/tweezers. Do not use the FLEX SHIELDING LID ASSY again. 20) Carefully disconnect the LCD with SS-93.
Page 16
Nokia 3720 Classic RM-518 Service Manual Level 1&2 22) Release the CAMERA MODULE using SS-88. 23) Pull out the USB COVER. 24) Do not use the USB COVER again. 25) Carefully remove the ANTENNA MODULE ASSY 26) Separate the ANTENNA MODULE ASSY inclusive using SS-93.
Nokia 3720 Classic RM-518 Service Manual Level 1&2 11. ASSEMBLY HINTS • Note: All devices with damage caused by liquid and/or intrusion need to be sent to Level 3 for repair. • Visually check the A- and B-COVER for damages (for example rubber gaskets, cover hooks/clips).
Nokia 3720 Classic RM-518 Service Manual Level 1&2 11.2 Screw order and torque 1) Tighten the screws to the torque of 18 Ncm in 2) Tighten the screw to the torque of 7 Ncm in the the order shown. order shown.