Starting Up Appliance; Installing And Adjusting The Blade - Secabo C30III Operating Instructions Manual

• In FlexiStarter under Edit / Settings / Tools / Plotting and cutting, remove the
check mark in front of Connect to local Production Manager over TCP/IP
(applies only for users on local PC).
CAUTION! These settings must be made before starting a plotting job; they
do not become effective for plotting jobs already active!

5.4 Starting Up Appliance

Ensure that sufficient space is present for the vinyl transport in front of and in back
of the unit. The vinyl cutter should be operated only in clean and dry surroundings.
• Connect the plotter to a 220 V wall socket with the power cable provided.
• Then switch the plotter on. Caution! After switching on, the cutting head
initially moves to the right.

5.5 Installing and Adjusting the Blade

• Take one of the cutting blades supplied and place it in the blade holder so
that the sharp side extends at the front. The blade is held by a magnet in the
blade holder.
• Adjust the cutting depths by turning the front cap.
• The depth is initially set correctly when you can carefully move your fingertip
across the blade and feel only a light scratching. Since the depth adjustment
for the blade depends on the material, it may be necessary to change it later
(as a rule 0.05 mm to 0.1 mm).
• Press the pin on the rear of the blade holder to remove and replace the blade
at any time. Caution – Injury hazard!
The various material thicknesses require different blade settings or even special
blades; it may therefore be necessary to repeat the adjustment described above.
9