Download Print this page

Remote Operation - MTX Thunder Sports MUDBTRC Owner's Manual

Bluetooth remote control

Advertisement

REMOTE OPERATION

1. Play/Pause - The Play/Pause button gives you the ability to play or to pause the current track with
a single press. Holding the Play/Power button for 2 seconds will turn the unit On if currently Off or
Off if currently powered On. The unit will beep to indicate when power is turned Off.
Note:
a. The unit will stay on indefinitely as long as a Bluetooth device is actively paired to the
MUDBTRC.
b. The unit will turn Off after 5 minutes when there is no active Bluetooth device connection.
c. The Play/Pause button will illuminate when the unit is powered On.
d. The Play/Pause button will blink when the music track is paused.
2. Track Forward and Track Back - The unit will switch audio tracks being played by pressing the
track forward and track back buttons. Pressing and holding these buttons for 2 seconds will fast
forward or rewind the audio track that is being played.
3. Volume Up and Volume Down - These buttons will turn up or turn down the output of the Bluetooth
unit so any external connected amplifier output will go up or down accordingly. When the unit
has reached the minimum or maximum output level, the unit will beep to indicate that no further
adjustment is possible.
4. Bluetooth Auto-Pair Mode
a. Turn the unit On.
b. Search for MTX REMOTE from your device's Bluetooth menu
c. Select Pair.
INSTALLATION
The MUDBTRC can be used with any external 12-volt amplifier and can be mounted in a variety
of ways using the included hardware. The unit has three wires in its wiring pigtail. The red wire,
hot, should be directly connected to the vehicles positive battery terminal, the black wire, ground,
should be connected directly to the vehicle's chassis where paint has been removed or the negative
terminal on the battery, and the blue wire, remote, should be connected to the remote wire input on
the external amplifier being used. When the MUDBTRC is powered On, a remote signal will be sent
from the MUDBTRC to the connected amplifier, turning it On.
The unit can be surface, flush, or clamp mounted using the included hardware.
M T X . C O M
3

Advertisement

loading