Table of Contents
Advertisement
12. A Logon window will appear, requiring you to enter a User name and
Password. Make up a user name and password (if you haven't already),
enter it here and click the OK button. Do not click the Cancel button or
press the Escape key. Clicking either of these buttons will prevent you from
logging into the network. If the logon does not appear or if it does not allow
you to log on, refer to the Troubleshooting section.
13.Once you are at the Windows ME desktop, double-click the My Network
Places icon, the Entire Network icon, and then the Your Workgroup icon.
You should see one icon for the entire network and the names of the other
PCs on the network.
If you can see your computer along with all the other computers on the
network in Network Neighborhood, then the Windows ME network con-
figuration is complete. Continue with Appendix B: Sharing Your Files and
Printers if you want your PC's data or printer to be available to others on
the network. You may stop here, however, if you wish to configure File and
Printer Sharing at a later time.
Refer to the Troubleshooting section if:
• You don't see anything at all in Entire Network and have pressed the F5
key on your keyboard a few times to refresh the screen.
• You only see your own computer in Entire Network.
• You see all computers on the network except yours and have tried press-
ing the F5 key a few times.
• You only see computers that are running the same operating system as
you and you don't see any others.
35
Instant EtherFast
®
Series
EtherFast
®
10/100 LAN Card
Chapter 8: Manual Installation and
Setup for Windows NT
Overview
The following instructions will set up the EtherFast
computer running NT 4.0 Server/Workstation. You should have your original
Windows NT CD-ROM available
during the installation, as you
might be asked to supply it.
Always consult your NT docu-
mentation if you have questions.
To install the network driver for an NT 4.0 Server or Workstation
1. Log into Windows NT as an administrator.
2. Click on Start, Settings, Control Panel, and then double-click on the
Network icon.
3. If you have not previously installed Windows NT networking on your com-
puter, the following message will appear:
• If you see this message, click the Yes button to install NT networking along
with the EtherFast
®
10/100 LAN Card's network driver, and continue with
step one on the following page.
• If you don't see this message, NT networking is already installed. Skip to
the Installing the EtherFast
®
Networking is Already Installed section.
®
10/100 LAN Card in a
10/100 LAN Card Network Driver if
36
Advertisement
Table of Contents
