Power (Led); Error (Led); Cartridge (Led); Clean (Button) - Samsung SRP-500 Programmer's Manual

3.4.1 Power (LED)

This indicator light is on when the power is turned on. It blinks when the printer is the self-
test printing standby state.
Always wait until this indicator light stops blinking before you start using the printer and
before you turn it off.

3.4.2 Error (LED)

When this indicator light is on but not blinking, it means that the printer is no paper or
almost out of paper or the printer covers are open. When this light is blinking, there is an
error. If you see this light is blinking, turn off the printer for a few seconds and then turn it
back on.

3.4.3 Cartridge (LED)

The right indicator is for the right cartridge and the left indicator for the left cartridge. If the
printer is a single color printer, the left cartridge indicator will be used. In the most cases,
the left cartridge is black, and the right is a color. This indicator light (LH/RH) blinks when
the cartridge is almost out of ink and stays on when the cartridge(s) is removed.

3.4.4 Clean (BUTTON)

Use this button to clean the printer head or to enter MENU mode.

3.4.5 Feed (BUTTON)

Use this button to feed paper or to start self-test and for hexadecimal dump mode.
3.5

DIP switch setting

Although the factory settings are best for almost all users, if you have special
requirements, you can change the DIP switch.
DIP SW1
Switch
1-1
Emulation Selection
1-2
1-3 Auto cutter
1-4 Pen
1-5
1-6
1-7 Near end sensor
1-8 Low ink check
EPSON
STAR
CITIZEN
2002. 1. 8.
Function
Refer to the following table
Enable
one pen
Reserved
Enable
Disable
1-1
OFF
OFF
ON
Programmer's Guide
ON OFF
Disable
two pen
Disable
Enable
1-2
OFF
ON
OFF
C
OMMANDS
Default
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
14