F E At U R E S - O P E R At I O N S; Operating Instructions - Sunbeam Aer1 SAP8422-CN Instruction Leaflet

F E AT U R E S - O P E R AT I O N S

HIGH, MEDIUM AND LOW SPEED SETTINGS
For optimum air filtration, operate your Sunbeam
purifier continuously on the MEDIUM (2) setting. Its
rugged motor has been designed to give many years of
use. For quieter operation (such as in a bedroom), select
the LOW (1) setting. When high levels of air pollution are
present, select the HIGH (3) setting to quickly circulate
and filter the room air.
FILTER CHECK INDICATOR
Your Air Cleaner includes Aer1
specially designed to eliminate odors!! The Aer1
Eliminator Filters last 4 months. See back panel for other
filter options.
The Filter Check Indicator is designed to remind you to
check and change your filters every 4 months. To reset
the Filter Check Indicator, press and hold the Filter Reset
button ( ) for 3 seconds only under working mode. The
Indicator light will blink three times and turn off.
BEFORE USE
1. Carefully unpack your Air Purifier. Select a firm level
place where there are no obstructions to the air inlet
or filtered air outlet.
2. Access your Aer1 Filters. If the filters are covered
TM
by bags when shipped, remove plastic bags before
use and place filters into unit. (Reference FILTER
REPLACEMENT INSTRUCTIONS).

OPERATING INSTRUCTIONS

IMPORTANT:
• Remove all plastic bags from filters before use.
• DO NOT POINT FILTERED AIR OUTLET TOWARDS WALL.
1. Plug into a 120V AC electrical outlet. The Filter Check
Indicator light will blink three times to indicate that
the feature has been activated.
2. Select the desired operating speed; HI (3), MEDIUM
(2), LOW (1), by turning Speed Control Knob to the
appropriate setting. For optimum air filtration, it is
air
®
Odor Eliminator Filters,
TM
Odor
TM
recommended to operate the air purifier
continuously. Its rugged motor has been designed to
give many years of use.
3. To release negative ions into the filtered air, press the
ionizer button ( ) to ON and the outer ring of the
button will illuminate in blue.
NOTE: The ionizer will not work unless the unit is
running.
Fig. 1
A
C
D
G H I
F
B
E
A. Control Panel
B. Speed Control Knob
C. Filter Reset Button
D. Filter Check Indicator
Light
E. Ionizer Button
F. Filtered Air Outlet
G. Aer1 Filters
TM
H. Washable Foam Pre-Filter
I. Air Inlet Grill