Advertisement
Welcome
We hope that you enjoy your new Trackstick, and that you
find it both practical and easy to use. Trackstick uses GPS
(Global Positioning System) to track its location and the
telemetry is downloaded to your Windows based personal
computer.
Getting Started
Your Trackstick was shipped ready to use. Follow these easy
steps to get started:
Software and Device Setup
1. Install the Trackstick Configuration Manager on your
Window's based personal computer. The software
can be downloaded at
http://www.sagetracker.com/trackstick_utilities.htm
2. Insert the DC power port to a 12V supply. Connect
the other end to Trackstick.
3. Take Trackstick for a test drive (the dashboard of a
vehicle is a great location for the first test).
4. Plug Trackstick into computer USB port and continue
with the software installation as instructed.
5. When installation is complete, run Trackstick Manager
software.
The configuration manager will allow you to set the reporting
interval and the power mode of the device. See the "Help"
section within Trackstick Manager for additional details.
Tracking Instructions
1. Trackstick always requires an unobstructed view of
the sky to receive satellite signals. Never place the
Trackstick in a vehicle's trunk or in any other object
made of metal. Clothing, handbags, backpacks, most
automobile windshields, fiberglass and other non-
metallic objects will not normally interfere with the
Trackstick's operation.
2. When turning on for the first time, always leave the
Trackstick in full power mode for at least fifteen (15)
minutes with a clear view of the sky. The
should illuminate after about three (3) minutes if a
good satellite signal is available.
3. If the
minutes, move the Trackstick to another location to
receive a better satellite signal and wait an additional
fifteen (15) minutes.
TIP: A good way to familiarize yourself with the device is to
place the unit on the dash of your vehicle for the first day of
use. This will allow the device to collect data in a location
with good GPS visibility.
Downloading Recorded Data
WARNING: Be sure to install the Trackstick Manager
software before plugging Trackstick into your
computer.
Once the software has been installed, plug the Trackstick
into your computer's USB port. Click the Trackstick Manager
icon and select "File", "Download Trackstick Data". You will
be prompted for a name to save the file in the Trackstick
folder.
The recorded Trackstick information is presented in four
different ways (All, Tracks, Routes, and Dates). See the
"Help" section within Trackstick Manager for additional
details.
3
GREEN
LED does not illuminate after a few
GREEN
LED
4
Advertisement
