Table of Contents
Advertisement
OPERATING INSTRUCTIONS
8
Air inlet (side)
Air inlet( rear)
9
Air outlet
10
Signal receiver
A
Signal receiver
B
Model Name And Dimensions
MODEL
WIDTH mm
9000 Btu
680
12000 Btu
770
18000 Btu
905
24000 Btu
1030
Indoor unit
1. Front panel
2. Air inlet
3. Air filter
4. Air outlet
5. Horizontal air flow grille
6. Vertical air flow louver(inside)
7. Display panel
NOTE: The actual shape of the indoor unit
you purchased may be slight different
on front panel and display window.
Outdoor unit
8. Connecting pipe
9. Connecting cable
10. Stop valve
NOTE:
All the pictures in this manual are for
explanation purposes only. Your air conditioner
may be slightly different. The actual shape
shall prevail.
VLED Display Window
OPERATION indication lamp
This lamp illuminates when the air
conditioner is in operation.
TIMER indication lamp
Lights up during Timer operation.
DEFROST i
ndication lamp
(Enabled on cooling & heating models only):
Lights up
when the air conditioner starts
defrosting automatically or when the warm
air control feature is activated in heating
operation.
Temperature indicator
Displays the temperature settings when the
air conditioner is operational.
Displays the malfunction code.
HEIGHT(mm)
DEPTH(mm)
255
180
255
188
275
198
315
220
5 5
Special functions
Refrigerant Leakage Detection
With this new technology, the dipsplay area will appear EC and the indication lamps
continue flashing when the outdoor unit detects refrigerant leakage.
Louver Angle Memory Function(optional):
Within the scope of safety angle, it will memorize the open angle of horizontal louver.
If it exceeds, it will memorize the boundry of safety angle. In the following circumstances,
it will return to standard angle: 1) pressing the turbo or manual control button, 2)unplug
and then plug in the machine.
So we strongly suggest that the open angle of the horizontal
louver should not be set too small, in case the condensed water forms and drops from the
horizontal louver.
SELF CLEAN function Optional
Function used after the Shut Down of cooling operation to clean the Evaporator
and keep it as fresh for the next operation.
The unit will operate as following sequence : FAN ONLY mode at Low fan speed--Heating
operation with LOW fan speed(applicable to cooling & heating modles only) ---FAN ONLY
operation--Stop Operation---Turn off.
Note:
This function is only available under COOL(AUTO COOL, FORCED COOL) and DRY mode.
Before select the function, it is recommended to run the air conditioner under Cooling
operation for about half an hour. Once the Self Clean function is activated, all TIMER
setting will be cancelled.
During Self Clean operation, when press the SELF CLEAN button on the remote
controller again will stop the operation and turn off the unit automatically.
CLEAN AIR function(on some models)
Improving the quality of indoor air is one of the purposes of an air conditioner. This air
conditioner is equipped with ionizer or Plasma Dust Collector(Depending on specific
configuration of the model). With the anions generated by Ionizer, the air circulation
of the air conditioner fills the room with refreshing, natural and healthy air. The Plasma
Dust Collector generates a high voltage ionization zone, through which the air is
converted to plasma. Inside the air most of the dust, smoke, and pollen particles are
captured by the electrostatic filter.
Anti-mildew function Optional
When turns off the unit on COOL, DRY , AUTO (Cool) mode, the air conditioner will continue
operating for about 7-10 minutes (depending on models) with soft wind.This will help to
dry up the condensed water inside the evaporator, and prevent the breeding of mildew.
Under Anti-mildew operation, do not restart the air conditioner until the unit iscompletely off.
OPERATING INSTRUCTIONS
,
,
6 6
Advertisement
Table of Contents
