Download Print this page

Amplicomms Watch & Care V131 User Manual page 9

Available languages

Registration

For operation you will have to register your transmit-

ter (camera) to your Amplicomms Watch&Care

V130/132:

1 Switch the transmitter off (switch set to OFF). Re-

move the batteries of the receiver for a few se-

conds if necessary.

2 Switch the receiver on.

3 Press and hold down the button

appears in the display.

4 Use the

mera [C1] ... [C4].

5 Press the

ckers for approx. 10 seconds. During this time,

you must perform steps 6 and 7.

6 Switch the transmitter on (switch set to ON).

7 Press the registration key on the

back side of the transmitter. After a

short time the video from the

transmitter will appear on the

screen if the registration was suc-

cessful. If the registration failed,

"Out of Range" appears on the

screen.

(See Watch&Care V130/132 user guide for costs and hours of operation)

UTTING THE

buttons to select the desired ca-

button briefly. The Link LED fli-

Helpline UK 0844 800 6503

NIT INTO

PERATION

until [C1]

Table of Contents