mactec MT070 Instruction Manual

Cordless driver drill

Advertisement

Quick Links

INSTRUCTION MANUAL
Cordless Driver Drill
MT070
MT071
011794
IMPORTANT: Read Before Using.
1

Advertisement

Table of Contents
loading

Summary of Contents for mactec MT070

  • Page 1 INSTRUCTION MANUAL Cordless Driver Drill MT070 MT071 011794 IMPORTANT: Read Before Using.
  • Page 2: Specifications

    ENGLISH (Original instructions) SPECIFICATIONS Model MT070 MT071 Steel 10 mm 13 mm Wood 25 mm 36 mm Capacities Wood screw 5.1 x 63 mm 6 mm x 75 mm Machine screw 6 mm High (2) 0 - 1,400 No load speed (min...
  • Page 3 a cord suitable for outdoor use reduces the risk of preventive safety measures reduce the risk of electric shock. starting the power tool accidentally. If operating a power tool in a damp location is 20. Store idle power tools out of the reach of unavoidable, use a ground fault circuit children and do not allow persons unfamiliar interrupter (GFCI) protected supply.
  • Page 4 GEB051-2 If electrolyte gets into your eyes, rinse them out with clear water and seek medical CORDLESS DRILL SAFETY attention right away. It may result in loss of WARNINGS your eyesight. Do not short the battery cartridge: Use auxiliary handle(s), if supplied with the Do not touch the terminals with any tool.
  • Page 5: Functional Description

    When the remaining battery capacity gets low: • FUNCTIONAL DESCRIPTION If you pull the switch trigger, the motor runs again but stops soon. In this case, to prevent over discharge, remove the battery cartridge CAUTION: from the tool and charge it Always be sure that the tool is switched off and the •...
  • Page 6: Adjusting The Fastening Torque

    Speed change ASSEMBLY 1. Speed change CAUTION: lever Always be sure that the tool is switched off and the • battery cartridge is removed before carrying out any work on the tool. Installing or removing driver bit or drill bit 1.
  • Page 7: Drilling Operation

    CAUTION: MAINTENANCE Make sure that the driver bit is inserted straight in • the screw head, or the screw and/or bit may be CAUTION: damaged. Always be sure that the tool is switched off and the • NOTE: battery cartridge is removed before attempting to When driving wood screws, predrill pilot holes to •...
  • Page 8 Makita Corporation www.makita.com 884990-3...

This manual is also suitable for:

Mt071

Table of Contents