Summary of Contents for Laipac G30R-L
- Page 1 G30x-L GPS Data Logger Receiver Embedded Solutions Laipac Technology, Inc. 55 West Beaver Creek Rd. Unit 1 Richmond Hill Ontario L4B 1K5 Canada Tel: (905) 762-1228 Fax: (905) 763-1737 http://www.laipac.com...
-
Page 2: Table Of Contents
1. Introduction ....................3 1.1 Specification ..................4 2. Installation ....................5 2.1 Connecting G30 ( For G30R/G30R-L, PS/2 type ) ......5 2.2 Connecting G30 ( For G30U/G30U-L, USB type ) ......6 3 Using Data Logger Demo Program ............8 3.1 Getting Connected ................9 3.2 Uploading Data .................10... -
Page 3: Introduction
Two versions of G30x are available. G30R comes with a 9-pin serial connector, and G30U comes with a USB connector. Also both modules can come with (G30R-L, G30U-L) or without (G30R, G30U) data logger function. These receivers are well suited to system integrators or users who use popular PC compatible system, notebook PC, PDA and “off-the-shelf”... -
Page 4: Specification
Map Datum WGS-84 WGS-84 Data Logger 16M bit (up to 15hrs for PVT 16M bit (up to 15hrs for PVT data, data, 1Hz update rate) (G30U-L 1Hz update rate) (G30R-L only) only) Interfaces Input Voltage +5V DC +5V DC Power Cons.(Avg.) 0.3 watt... -
Page 5: Installation
Laipac Technology, Inc. 2. Installation 2.1 Connecting G30 (For G30R/G30R-L, PS/2 type ) Step1. Plug RS-232 to COM port of your Notebook PC or Handheld PC. Step2. Plug PS2 connector in the PS2 mouse outlet of your Laptop PC or Handheld Place your PC in a safe and plane surface inside the vehicle. -
Page 6: Connecting G30 (For G30U/G30U-L, Usb Type)
Laipac Technology, Inc. Par ity : None Stop bit : 1 Flow contr ol : None. (4) The format of NMEA messages is illustrated on Software Data section. (5) To prevent from the poor contact, the 4-pin mini din connector was designed as good fitting. - Page 7 Laipac Technology, Inc. COM port is for the setup of SiRF demo program(SIRFDEMO.exe) and some mapping software which supports GPS function. For instance, if it shows COM3, you have to switch to the COM port when you start SiRF demo program. Please notice the action, it is very important.
-
Page 8: Using Data Logger Demo Program
Laipac Technology, Inc. 3 Using Data Logger Demo Pr ogr am GPS Data Logger demo program is a Win98/Win2000 based application software to demo and test functions of G10/G30. This demo software will, according to the configuration, start recording upon power on and stop recording on running out of storage. Users may use the demo program to: ˙Upload recorded data... -
Page 9: Getting Connected
Laipac Technology, Inc. 3.1 Getting Connected First, connect G30-L to the USB/RS232 slot of your PC. Launch demo program and use “select comport” button (first speed button) to select the correct COM port connected. When COM port is correct selected, then press “connect” speed button to connect G30-L. -
Page 10: Uploading Data
Laipac Technology, Inc. 3.2 Uploading Data Use “data sync” speed button to upload record. Users need to specify a file to save the uploaded data. A blue bar will display to indicate the upload progressing. Use “erase” speed button to clear logged data. After uploading the recorded data, users need to “erase”... -
Page 11: Data Review
Laipac Technology, Inc. 3.3 Data Review Use “analysis”speed button to read back and display recorded data. (see Fig 4) Some summary data is shown in the message area. The diameter of the yellow circle is 20 meters. The diameter of the green circle is 100 meters... - Page 12 Laipac Technology, Inc. Use “Load map” button to load a map file (in BMP format) as a back map. (see Fig 5) The loaded map file will automatically fit into the current display range. Fig 5 Background map loaded...
-
Page 13: Troubleshooting
Laipac Technology, Inc. Users can use “Adj. Map” button to set the correct map range in WGS84 (see fig 6) Use “Clear map”button to remove the background map. Use “Zoom In” “Zoom Out” buttons to change view range. Fig 6 Adjust the map range...
Need help?
Do you have a question about the G30R-L and is the answer not in the manual?
Questions and answers