Download Print this page

Ada MICROTUBE 100 Owner's Manual

Stereo guitar power amplifier

Advertisement

MICROTUBE 100
OWNER'S MANUAL
(version 1)
th
Originally written by ADA SIGNAL PROCESSORS, INC. Scanned and edited by Jur at 17
of july 2002. Original
ADA logo edited and rendered by Barend Onneweer of Raamw3rk. (http://www.raamw3rk.net) The version of this
manual is copyrighted and may not be sold or placed on a website without permission of the editor.
Release No.1 for http://www.ada-mp1.com

Advertisement

loading

Summary of Contents for Ada MICROTUBE 100

  • Page 1 Originally written by ADA SIGNAL PROCESSORS, INC. Scanned and edited by Jur at 17 of july 2002. Original ADA logo edited and rendered by Barend Onneweer of Raamw3rk. (http://www.raamw3rk.net) The version of this manual is copyrighted and may not be sold or placed on a website without permission of the editor.
  • Page 2: Table Of Contents

    CONTENTS Introduction Features Specifications Precautions SetUp Speaker Impedance Quick Set Up Chart Tube Replacement Warranty Returning Units For Service Page 2...
  • Page 3: Features

    ADA MP-1 MIDI TUBE PREAMP and ADA SPLIT-STACK SPEAKER CABINETS. Your new MICROTUBE 100 will preserve all the tone and fidelity from your guitar, preamp, and effects units, while delivering warm and clean power only available from a tube amplifier.
  • Page 4: Precautions

    Note: Refer to the QUICK SET UP CHART of this manual for connection diagram. Connect stereo inputs (A & B) on rear panel of MICROTUBE 100 to the outputs of your preamp or effects device, using line level outputs. For bridged or dual mono operation, connect preamp or effect output to the mono input of the MICROTUBE 100.
  • Page 5: Speaker Impedance

    It is important to always "match" your speaker system to your power amplifier, especially when using component systems such as the ADA MP-1 & MICROTUBE 100 power amplifier. A proper impedance match will give you optimal performance and keep your power amp in a "safe operating area"...
  • Page 6 Page 6...
  • Page 7 Page 7...
  • Page 8 The ADA SPLIT-STACK speaker cabinet uses two 16-ohm speakers that are wired in parallel, which makes the cabinet an 8-ohm load. Only ADA SPLIT-STACK speaker cabinets offer you the versatility of parallel and series extension ports, allowing you to combine cabinets in various impedance configurations.
  • Page 9: Tube Replacement

    MICROTUBE 100. This warranty remains valid only if repairs are performed by ADA or its agent, and provided that the serial number on the unit has not been defaced or removed. This warranty is expressly in lieu of all other warranties either expressed or implied.