OFF position when matching the frequency used by another manufacturer. Always leave the RN switch in the ON position when using Lifeline Amplification Systems equipment. This will ensure the maximum signal/noise ratio of 80db. (Both Transmitter & Receiver must be in the If you have questions ON position to use the RN feature.)
4. MIC SENSITIVITY 5% charge life left. The factory setting for the Mic Sensitivity 8. TALK/MUTE SWITCH switch is MED. You may change this to Rotate switch to TALK to turn on the HI or LO depending on the user’s voice microphone.
Page 4
10. CHANNEL SELECTOR SWITCHES Please refer to the Frequency Compatibility If your Transmitter is in the locked position, Charts on page 9 for specific frequencies the LOCK symbol will appear on the graphic and compatibility with other manufacturers. display. To unlock, simply press and hold Note: Always try to use wide band either the UP or DOWN selector button frequencies first.
Lifeline Amplification 3. CHANGE THE STATUS OF A CHANNEL Systems. (LOCKED OR UNLOCKED): Enter PRO- Your Champion Series Charger will safely GRAM mode as stated on number 1 above, operate when plugged into the transmitter reverse procedure for number 2 above.
Hydride batteries may result in physical leave the RN switch in the ON position us toll-free: harm, destruction of property and/or fire when using Lifeline Amplification Systems 1-800-236-4327 and will void the manufacturer’s warranty. equipment. This will ensure the maximum 3.
Receiver Operation RECEIVER DISPLAY Letters and numbers Small Dots indicate the indicate the channel relative RF signal strength. the unit is tuned to. When there is no signal the unit is squelched. 1. TURN UNIT ON Plug input device (headset) into jack on the top of the receiver.
NiMH batteries supplied by Also refer to your signal strength meter on Lifeline Amplification Systems. the graphic display. Your Champion Series Charger will safely 5. FIND AUDIO TRANSMISSION operate the receiver even when the batteries You may also find your frequency needed...
• Make sure you have signal strength dots in the display. AUDIO IS DISTORTED. • Make sure you’re using a Lifeline Amplification Systems approved microphone. • Lower the Mic Sensitivity Switch (see #4 on page 3) to see if this makes a difference.
Page 11
• The Transmitter uses the microphone cable as an antenna and as such, the range will vary depending on the location of the receivers compared to the transmitter. • If you experience dropouts, please call Lifeline Amplification Systems. BATTERIES NOT CHARGING.
BATTERIES NOT CHARGING • Check to make sure the battery switch is in the NiMH position. • Be sure to use a Lifeline Amplification approved Charger. • Use ONLY NiMH batteries provided by Lifeline Amplification. Never try to charge alkaline or NiCAD batteries! TRANSMITTER WILL NOT WORK •...
Need help?
Do you have a question about the Champion series and is the answer not in the manual?
Questions and answers