Volume Adjustment; Audible Beep Confirmation; Resetting The System - Jensen VX3022 Operation Manual

Mute
Press the volume knob on the front panel or press the [MUTE] Button on the
remote control to mute the volume from the unit.

Volume Adjustment

Volume Increase/Decrease
To increase or decrease the volume level, turn the rotary encoder on the front
panel. When the volume level reaches "0" or "50", a beep sounds, indicating that
the adjustment limit has been reached. The TFT screen displays the volume level
for 3 seconds.

Audible Beep Confirmation

An audible beep tone confirms each function selection. The beep tone can
be disabled through the Setup menu.

Resetting the System

Soft Reset - To correct a system halt or other illegal operation, use the tip of a pen
to press and release the Reset Button located just below the front panel rotary
encoder (volume) knob.
For a Hard Reset - Go to "Settings" > DVD tab > Load Factory > Reset. After a "System
Reset", the unit will restore all default settings.
Change Aspect Ratio (DVD / AV In Sources Only)
Press the [WIDE] button on the remote control to adjust the aspect ratio.
Image Settings (DVD / AV In Sources Only)
1. Enter image setting mode by pressing the [PIC] Button on the remote control.
2. Select the item to be adjusted and touch the Left or Right direction icons
[ ]/[ ] on the user interface to adjust the value.
3. To exit image setting mode, press the [PIC] Button on the remote control again
or simply stop making adjustments.
[RESET] Button
Figure 5. System Reset Button
Figure 6. Image Settings Screen
13
VX3022