Advertisement
CHARGING THE PCC
•
Attach the USB end of the charging cable into the wall charger
•
Attach the other end of the charging cable into the input port of the portable
charging case (PCC)
•
Plug the charging unit into the wall. The input LED will turn red indicating that
the charging is starting, and it will keep being red during the charging period.
•
The input LED will turn green when the PCC is fully charged, and will keep on
being green until you stop the charging.
•
Recommended charging time: 2.5-3 hours.
CHARGING THE BATTERY WITH PCC
•
Simply screw the battery into the corresponding charging hole in the PCC. Do
not use any force while doing this.
•
The output LED will turn red once a solid connection is made. The battery
LED will also turn on at the same time. The output LED will keep being red
during the charging period.
•
When the battery is nearly fully charged (when battery voltage comes up to
4.2V), the battery LED will go off and the charging procedure is still going on.
The output LED will turn green and will keep being green for 3 more minutes.
When the charging is fully completed, the output LED goes off and the PCC
will automatically shut down the charging circuit to save power.
Remarks:
There are intelligent microchips inside both the battery and PCC,
providing an automatic cut-off function and overcharge protection.
Notice:
The output LED will keep blinking red to indicate that the PCC needs
recharging when its voltage is under 3.3V. You can still charge the battery with the
PCC at this time. When the voltage goes below 3V the PCC will stop working and
run in to a safe mode to protect itself.
CHARGING THE BATTERY WITH USB
Gently unscrew the cartomiser by turning counter clock-wise. Once removed,
gently screw the battery onto the USB charger's corresponding thread. Plug the
USB charger into your PC, laptop or your Maverick wall charger. The battery light
should flash 5 times once a solid connection is made with the charger.
DO NOT OVER TIGHTEN BATTERY INTO CHARGER as it can ruin the charging unit.
The charger should turn from green to red, indicating the battery is charging. Once
the light on the charger turns green, your Electronic Cigarette battery is now ready
and fully charged. Charging must be within normal room temperatures.
BATTERY LED BLINKING NOTICE
•
2 times, it indicates that you have taken a long puff which has been
over 5 seconds
•
10 times, it indicates that the battery is in need of recharging
MAINTENANCE
•
Be sure to keep your battery threads and charger threads clean. This can be
done using a dry tissue. Cleaning your threads will provide a good connection
ensuring a proper charge and good vapour production. If your connections
are not clean the battery might not charge or vapour production might be
low.
When you put the whole E-cigarette into the PCC, keep the
cartomiser up. DO NOT put the E-cigarette upside down;
otherwise liquid may leak into the PCC from the cartomiser.
PRECAUTIONS
•
Only Maverick supplied accessories should be used and the correct operation
procedures must be followed to prevent malfunction and damage to the
product. We do not accept warranty claims if you use other operation
procedures other than those stipulated herewith.
•
Keep your E-cigarette and PCC away from other articles such as keys and coins
which could cause cosmetic or functional damage to your E-cigarette and PCC.
Warranty claims for cosmetic damage will not be accepted.
•
Should a problem arise with your E-cigarette or PCC please contact us and
do not try to dismantle yourself. Opening the battery compartments or PCC
inside cabin will result in complete malfunction and void the warranty.
•
Keep away from high temperature extremes and humidity.
•
Keep the whole kit out of children's reach and avoid improper operation.
MaverickCigs
PO Box 63296 London N2 2DD
t:
020 3286 0229
e:
info@maverickcigs.com
www.maverickcigs.com
Advertisement
