Echostreams 4U 96-Bay Quick Manual

Thank you for purchasing the 4U 96-Bay SAS Storage System!
1.
Check the content
your package contains the following:
# Description Image / Description
1 4U 96-Bay
Enclosure
2 Drawer
3 HDD Tray
4 Rail Kit
5 Serial Cable
6 This Quick Guide
7 Packaging
If any items are missing, please contact your authorized reseller or sales
representative
2.
Get familiar with the unit.
4U96 enclosure arrives with no drawers installed. The drawers
are shipped with separate packaging. The unit has seven
expanders: one master expander at the back of the unit, six
slave expanders in each drawer.
Front view
Drawer 1 Drawer 2 Drawer 3 Drawer 4 Drawer 5 Drawer 6
Enclosure
Ear
HDD LED:
(Solid) Disk Offline
(Solid) Disk Online
(Solid) Disk in RAID / OS
(Blink) Disk Activity
(Solid) Disk Error
DRAWER LED:
(Solid) Drawer Normal
(Blink) Drawer Component Faulty e.g. Fan Reading Error
Rear view
Fan Mod. Fan Mod. Fan Mod.
Drw. 6 Drw. 5 Drw. 4
SAS UP
Ports
SAS DOWN
Ports
Slide
Rail
Power Power Master
Connector Connector Expander
1 2 Module
4U 96-Bay Quick Guide
Version 1.20 Release 2014-07-10
of the box. Please confirm that
Qty
1
6
16 per
drawer
1 set
1
1
2 set
Drawer Drawer Drawer
Handle Latch Panel
ENCLOSURE LED:
(Solid) Enclosure Normal
(Blink) Faulty on any Drawer
(Solid) Enclosure Error
(Solid) Drawer Critical Error
Fan Mod. Fan Mod. Fan Mod.
Drw. 3 Drw. 2 Drw. 1
A
B
A
Management
B
Port
Power Power
Power LED:
Connector (Solid) Off Switch
(Solid) On
3
3.
Setup the drawers
One drawers contains two container. Each container can hold
eight (8) 3.5" drives. One drawer encloses 16 hard drives.
8 Disks
Rear Container
4.
Remove the drive trays
illustration below for the directions. Repeat the step for the
other container.
1. Release the
thumbscrew lock
5.
Install drives into trays.
HDD sold separately.
1. Pull the
locking
mechanism
outward
2. Lift the tray
cover
6.
Install drive trays into drawers.
tightly to the drive tray. Close the lids of the drawer and secure
the thumbscrews afterwards.
7.
Mount the Power Center
enclosure (optional). Power Center sold separately. Refer to
Power Center quick guide for the detail of its functions.
by removing it from their boxes.
8 Disks
Front Container
from the drawer. See the
2. Open the cover
3. Remove the
drive trays by
pulling the ribbon
up or by lifting it by
the side (red
rectangle)
Follow the diagram closely.
4. Close the cover. Press at
these locations (arrows) to
secure the disk to the tray
3. Insert the
HDD. Note the
direction of the
data port
Fold the ribbon
at the back of the
Use the bracket to mount the
Power Center, and secure it
with screws