Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Circutor airREPEATER
- Page 1 Radio to radio repeater airREPEATER INSTRUCTIONS MANUAL M98250601-03-13A...
- Page 2 Pag 2 of 9 Instructions manual...
-
Page 3: Safety Warnings & Symbols
The term of the CIRCUTOR guarantee is two years from the date of purchase and is limited to refund of the purchase price, repair free of charge, or replacement of defective equipment that is returned to CIRCUTOR post-sales service within the term of the guarantee. -
Page 4: Table Of Contents
TABLE OF CONTENTS Safety Warnings & Symbols ......................3 Liability limitations ........................... 3 Recommendations prior to use ...................... 3 GENERAL OVERVIEW ........................5 INITIAL CHECK OVER ....................... 5 STANDARD COMPONENTS AAND ACCESORIES ................ 5 GENERAL DEVICE CHARACTERISTICS ..................5 TECHNICAL FEATURES ........................ -
Page 5: General Overview
With the device you should receive a compatible antenna. GENERAL DEVICE CHARACTERISTICS The airREPEATER is a radio to radio repeater which belongs to ZB-Connection devices family. It has the active function of maintaining radio traffic from and to other similar devices and it can also act as a parent device for battery-powered nodes of the same family. -
Page 6: Dimensions
STANDARDS 2006/95 EEC (LV Directive) General Legislation 99/5 EEC (R&TTE Directive) 2004/108 EEC (EMC Directive) EN 60950-1 (2006) +A11 (2009) Electrical and radiation safety EN 62479 – (2010) EN 61000-6-2 (2005) Electromagnetic Compatibility EN 61000-6-3 (2007) ETSI EN 301 489-1 v1.8.1... -
Page 7: Card Layout And Connection Diagram
ASSOCIATING THE DEVICE TO A COMPATIBLE NETWORK The process to associate airREPEATER to a RF network is the usual in all ZB-bridge routers. The association process is activated automatically by the device in case that the node does not have any network parameters assigned. -
Page 8: Led/Push-Button Interface
LED/PUSH-BUTTON INTERFACE The Repeater has three LED through which it is possible to obtain information on the device's operating state. Furthermore, the Repeater has a push-button which makes it possible to send commands to the device. Behaviour of LED indicators at the start-up: At the reset of the Repeater all LED indicators light for 2 seconds, then all flash fast for another 2 seconds and after the flashing the device starts the normal operation. -
Page 9: 10 In Case Of Malfunction
10 IN CASE OF MALFUNCTION In the event of questions or concerns regarding operation or malfunction of the device, notify Technical Assistance Service (S.A.T.) of CIRCUTOR, SA. SPAIN 902 449 459 INTERNATIONAL (+34) 93 745 29 00 Technical assistance Post-sales Department Vial Sant Jordi, s/n –...
Need help?
Do you have a question about the airREPEATER and is the answer not in the manual?
Questions and answers