Download Print this page

Tanaka TPS-200 Owner's Manual

Pole saw attachment

Download this manual

Model Numbers:

TPS-200

POLE SAW A

POLE SAW ATT

POLE SAW A

TPS-200

ISM, Inc. • 1028 4

www.tanakapowerequipment.com

TTA A A A A CHMENT

CHMENT

Supplier To The Outdoor Power Equipment Industry

Street SW • Auburn, WA 98001 • Phone: (253) 333-1200 • Fax: (253) 333-1212

Owner'

Owner' s Man

Owner'

s Man

ual

s Man ual

ual

s Man

ual

P/N 28577

Date 05-04-01

custsvc@tanaka-ism.com

Page 1 Owner’ s Man s Man Owner’ s Man s Man ual Owner’ Owner’ s Man Model Numbers: P/N 28577 TPS-200 TPS-200 TPS-200 TPS-200 TPS-200 Date 05-04-01 POLE SAW A POLE SAW A TTA A A A A CHMENT CHMENT CHMENT...
Page 2: Safe Operation
1. Introduction It is important that you read and understand your TANAKA brush cutter owner's manual as well as this manual. Please carefully review and observe all safety precautions and warnings. Careless or improper use of the unit may cause serious or fatal injuries.
Page 3 TPS-200 Owner’s Manual Installation of bar and chain 1. Remove chain bar clamp nut (2). 2. Remove the side case (1). (Fig.2-3) 3. Install, the chain bar (1) onto the bolt (2), then push it toward the sprocket (3) as far as it will go.
Page 4 TPS-200 Owner’s Manual Chain oil (Fig. 2-8) Fill up with chain oil (1). Always use good quality chain oil. When the engine is running, the chain oil is automatically discharged. NOTE! Add chain oil when its level lowers to one centimeter from bottom. (Fig. 2-8) ADJUSTMENT OF CHAIN OIL SUPPLY The chain oil quantity discharged through the lubrication system is factory-adjusted to the standard.
Page 5 TPS-200 Owner’s Manual 4. Maintenance Oiler port (Fig. 4-1) Clean the chain oiler port (1) whenever possible. Guide bar (Fig. 4-2) Before using the machine, clean the groove and oiler port (1) in the bar with the special gauge offered as an optional accessory.