Advertisement
Quick Links
INTRODUCTION
The SmartSpeaker™ line consists of three physically interchangeable speaker/baffle assemblies,
installation and finishing hardware. The speaker/baffle assemblies feature a cut-out for the 480 Dinky
Link™ Infrared Receiver. The systems are designed to be mounted in a wooden-studded plasterboard or
"lath and plaster" wall. They can be mounted in most ceilings, however special acoustic treatment may be
required. The addition of the Dinky Link Infrared Receiver adds the dimension of wireless remote control
extension to any installation.
DESCRIPTION
R-61 Rough-in Kit
• The Rough-in Kit consists of a pair of molded rectangular frames, flat perforated "wings" and thread-
cutting screws.
• The Rough-in Kit is mounted to the wooden studs during construction and is installed before the
plasterboard. It is not used in existing construction.
F63 Bezel/Grille
• The molded plastic bezel mounts directly to the wall or ceiling, with or without the Rough-in Kit. It is held
in place by four "dogs" which slip through the rectangular wall cutout and rotate into clamping position
as they are tightened.
• The bezel can be painted to match the mounting surface after it is installed.
• The perforated metal grille should be painted, if desired, before installation.
• The grille should be carefully installed after the speaker/baffle assembly has been mounted. Care should
be taken so that the edges of the grille do not scratch the finished surfaces of the bezel. The grille should
be painted, if desired, before installation.
INSTALLATION INSTRUCTIONS
S-62, S-64, S-66
SMARTSPEAKER
TM
1
Advertisement
Related Manuals for Xantech Smartspeaker s-62
Summary of Contents for Xantech Smartspeaker s-62
-
Page 1: Installation Instructions
INSTALLATION INSTRUCTIONS S-62, S-64, S-66 SMARTSPEAKER INTRODUCTION The SmartSpeaker™ line consists of three physically interchangeable speaker/baffle assemblies, installation and finishing hardware. The speaker/baffle assemblies feature a cut-out for the 480 Dinky Link™ Infrared Receiver. The systems are designed to be mounted in a wooden-studded plasterboard or “lath and plaster”... - Page 2 Fig. 1b • Xantech manufactures a complete line of Infrared Receivers, Keypads, Emitters, Audio Video & Speaker Switchers, Zone Controllers and a Multi- Channel Audio Amplifier.
- Page 3 Existing Construction • Before cutting any holes in the wall, be certain that the center of the opening is approximately centered between the studs, that there are no supports or fire Fig. 2a baffles in the area of the hole and that there are no electrical conduits, water or gas pipes in the way.
- Page 4 • The Dinky Link has two windows, one near the cable at the bottom and the other near the top. The lens should be centered over the top window. Remove the grille from the bezel. Drill a 3/8" hole in the grille. • A Xantech Unibit SD-200 Step Drill is recommended for drilling round holes in thin metal. Fig. 2d Fig.