Summary of Contents for Watersport the boost box WSI 1102
- Page 1 AutomAtic Volume control for BoAt StereoS WSI 1102 Wired Controller for Kenwood Marine Stereo Installation & Operation Instructions...
-
Page 2: Table Of Contents
Contents Installation Instructions ..........1 Chapter 1 Control Unit .............2 Power Cable ............4 Stereo Control Cable ..........5 Using the Boost Box ..........6 Chapter 2 Troubleshooting Guide ..........8 Chapter 3 Release of Liability ...........9 Chapter 4 Warranty ..............10... -
Page 3: Chapter 1 Installation Instructions
Installation Instructions Read through all instructions before installing. The Boost Box is designed to install easily on almost any boat with little or no wiring modifications. Simply attach the Control Unit to the boat with the enclosed Velcro tape, connect the Power Cable to the boat’s 12-volt power, and route the Stereo Control Cable to the back of the boat’s stereo. -
Page 4: Control Unit
Step 1 – Control Unit Installation The Control Unit must be mounted with the control knob facing the driver, and the unit must be mounted within 10° of level with respect to the boat’s waterline. The unit can be mounted either horizontal or vertical (see figures below). Attach the Control Unit to the boat with the enclosed Velcro tape, in a convenient location near the driver. - Page 5 NOte: If the unit is not mounted properly, it will not properly sense the boat’s acceleration. Below are some examples of InCORRECT mounting of the Control Unit. InCORRECT! Knob is facing up but should be facing the driver. Centerline (front to back) of the Control Unit is perpendicular, but should be parallel, to the boat’s waterline.
-
Page 6: Power Cable
Unplug the cigarette lighter for extended storage, as the Boost Box continues to draw a very slight current even when turned off. To order these adapters, visit the Watersport Innovations website at www.watersportinnovations.com. REaR SIdE Of UnIT... -
Page 7: Stereo Control Cable
clarion Boat Stereo Male end of Stereo Control Cable plugs Additional stereo remotes connect to female into the female plug Male end of Stereo end of Stereo Control Cable coming from the Control Cable plugs Additional stereo stereo control head into the female plug remotes connect to female Step 3 –... -
Page 8: Chapter 2 Using The Boost Box
S Y S T E M S , I N C . O. Box 550 104 Celtic Circle Madison, Alabama 35758 PROOF FOR APPROVAL Using The Boost Box Customer Part #: The Boost Box label LASI Item #: SS3578-001 art rev 001 Part Size: 4.27˝... - Page 9 CalIBRaTIOn: The Control Unit automatically calibrates (resets) its internal sensors every time it is turned on. This precisely calibrates the sensors to the boat’s level position in the water. To calibrate the Boost Box: 1. Ensure the boat is in flat water with no rolling waves. 2.
-
Page 10: Chapter 3 Troubleshooting Guide
If you are still having trouble with your Boost Box, please call Watersport Innovations technical support at (808) 809-9909 or send an email to: support@watersportinnovations.com... -
Page 11: Release Of Liability
Both purchaser and/or anyone utilizing the Boost Box acknowledges that their purchase and/or use of this device is conditional upon purchasers and users releasing and forever discharging Watersport Innovations, Inc., its directors, officers, employees, agents and/or dealers from any and all... -
Page 12: Warranty
If your Boost Box was installed by a dealer, you may contact your dealer directly or initiate a warranty claim directly with Watersport Innovations at your choice. If you purchased your Boost Box directly from the Company, contact us at the number or address below.