Inspect the blade for nicks and other damage and sharpen or replace when needed. Use caution when handling or replacing the slicer blade as it is very sharp and may cause injury if not properly handled. TECHNICAL SPECIFICATION MODEL MS220SG MS250SG MS300SG Voltage 220V/50Hz...
PARTS INCLUDED The following parts are included with your Maestrowave Slicer. Please check all packaging to ensure that all required parts are present before proceeding. Blade Sharpener Safety Guard Blade Removal Tool Lubricating Oil Instruction Manual MACHINE INSTRUCTIONS & PARTS 1.
CLEANING 1. Always turn off and unplug the slicer before cleaning. Always set the slice thickness regulator to the zero position to avoid cutting yourself. 2. Never use any chemical or abrasive products. Do not use a brush or any other type of utensils which could damage the different parts and surface of the slicer.
BLADE SHARPENING You should sharpen the blade when the slice thickness is not even or the slices are not continuous. Clean the edge of blade before sharpening. Pull the sharpener out and lubricate the sharpener axle so that it works well. Pull the sharpener out and turn 180°, press the right side stone down and put the sharpener to the working position.
Page 8
Sole Distributor R H Hall (Microwave) Ltd Hallco House, Beacon Court Pitstone Green Business Park, Pitstone Bedfordshire, LU7 9GY Telephone: 01296 663400 Fax: 01296 663401 E-mail: maestrowave@rhhall.com Website www.maestrowave.com...