Bicker BEA-630 Operating Instructions

Operating instructions

Industrial PC power supplies
Models: BEA-630, BEA-635, BEA-640

Intended use

This PC power supply is used for providing power to a computer or to PC components such as main board, hard disk, CD-
Rom etc. It is a built-in unit and therefore has to be installed in a metal housing. Only a qualified technician may install this
unit.

Safety instructions

Attention, danger of life!
It is strictly forbidden to modify, open, disassemble or reconvert the PC power supply!
Any use other than described in these operating instructions may damage the PC power supply and cause
dangers such as short-circuit, fire, electric shock etc.!
In case of damages due to disregard of these operating instructions any warranty will expire. Bicker will not be
responsible for any consequential damages!
We refuse any responsibility for damages to property or persons due to inappropriate handling or disregard of
these operating instructions. Any warranty will expire!
This is a class A device (industrial area).
This device may cause radio interference in residential areas.
In that case the operator can be asked to take appropriate measures..

Technical data

Before using this PC power supply, be sure to read the corresponding data sheet. If it is unavailable, you can read or
download it in the internet under www.bicker.de. Here you will find important information such as input voltage, output
rating, operating temperature, derating and more. The PC power supply may not be operated outside of these technical
data!
Installation
Only a qualified technician may install this unit. During installation the respective standards regarding electrical safety as
well as the standard EN 60950 have to be observed. Before installation, power-off the unit by switching it off and pulling
the main plug.
The PC power supply is an built-in unit and may only be used inside a metal housing. The housing must ensure a minimum
screening attenuation of 15 dB. For the installation of the PC power supply suitable screws (threading 6# - 32xL6) have to
be used.
The PC power supply is a product according to protection class I. During installation a secure connection of the grounding
equipment conductor between power supply and metal housing has to be ensured. The leakage current should not exceed
3,5 mA.
Cables should be run neatly and straight. Make sure the cables are not squeezed or damaged. Protect cables against sharp
edges in the housing. If necessary, fix them using cable straps and apply a protective padding to sharp edges. Make sure the
cables do not get into the computer fan.
During installation ensure that the PC power supply is adequately ventilated. Free circulation of air has to be possible. Also
make sure that the ventilation slots are not covered by objects, assembly parts or ribbon cables.
Bicker Elektronik GmbH || Zirgesheimer Straße 31 || 86609 Donauwörth || Germany
Tel. +49 906 70595-0 || Fax +49 906 70595-55 || E-Mail info@bicker.de || www.bicker.de
1/2