Remote Control Operation - LG EN 61000-3 Owner's Manual

Remote Control Operation

The Remote Controller transmits the signals to the system.
5
6
4
2
7
ON
11
8
13
14
Operation Mode
Cooling Operation
Auto Operation
Healthy Dehumidification Operation
Heating Operation
• Cooling Model( ), Heat Pump Model(
Signal transmitter
1
3
10
CANCEL
9
OFF SET
16
AUTO CLEAN
12
C/ F
17
18
15
Flip-up door
(opened)
)
1
START/STOP BUTTON
Operation starts when this button is pressed and
stops when the button is pressed again.
OPERATION MODE SELECTION BUTTON
2
Used to select the operation mode.
ROOM TEMPERATURE
3
SETTING BUTTONS
Used to select the room temperature.
INDOOR FAN SPEED SELECTOR
4
Used to select fan speed in four steps
low, medium, high and CHAOS.
JET COOL
5
Used to start or stop the speed cooling/heating.
(Speed cooling/heating operates super high fan
speed.)
CHAOS SWING BUTTON
6
Used to stop or start louver movement and set
the desired up/down airflow direction.
ON/OFF TIMER BUTTONS
7
Used to set the time of starting and stopping operation.
TIME SETTING BUTTONS
8
Used to adjust the time.
TIMER SET/CANCEL BUTTON
9
Used to set the timer when the desired time is obtained and
to cancel the Timer operation.
SLEEP MODE AUTO BUTTON
10
Used to set Sleep Mode Auto operation.
AIR CIRCULATION BUTTON
11
Used to circulate the room air without cooling or heating.
ROOM TEMPERATURE CHECKING BUTTON
12
Used to check the room temperature.
PLASMA(OPTIONAL)
13
Used to start or stop the plasma-purification function.
RESET BUTTON
14
Initialize remote controller.
2nd F Button
15
Used prior to using modes printed in blue at the bottom of
buttons.
AUTO CLEAN
16
Used to set Auto Clean mode.
˚C TO ˚F SWITCHING BUTTON
17
Used to switch temperature reading from Centigrade to
Fahrenheit.
HORIZONTAL AIRFLOW DIRECTION CONTROL
18
BUTTON (NOT ON ALL MODELS)
Used to set the desired horizontal airflow direction.
Operating Instructions
(Cooling Only)
(Heat Pump)
Owner's Manual 11