Advertisement
Unpack the unii care'fully and make sure that all accessories are put aside so they will not be lost.
Examine the unit For any possibility of shipping damage. 1.f your unit is damaged or fails to operate, notify your dealer immediately.
If your unit was shipped to you directly, notify the shipping company without delay. Only the consignee (the person or company
receiving the unit) can file a claim against the carrier fat- shipping damage.
We recommend that you retain the original carton and packing materials for use should you transport or ship the unit in the future.
r-----.------_-------..-------
_____.)
1 ~A~~~t~~"
LASEffi ~A~tA~t~~~ WWERI OP6N.
I
/
nwr STARE ItmQ BEAM.
I
/. - - - - - - - - - - .- -
- - - - - _ - - - - . _. . - - - - - - _,
~oca~too: Laser Pick-up Unit Gover inside this pr~&cP
--~---
..' _.
.
i.;=__~
---. _i;._
x__
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the
modifications are expressly approved II? tile instrucrioli manual. The user could lose the authority to operate this equipment if an unauthorized change or
modiftcation is made.
NOTE:
This equipmeili has heen tested and found to cornpI)/ with the knits for a Class B digital device, pursuant to Part 150f the FCC Rules. These knits are deslgned
to provide reasonable protection against haimfu :ntetietence
111 a residential installation. This equipment may cause harmful interference to radio
communications, if It isnot installed and used ~naccordance with ihe Instructions. However-, there IS noguaranteethat interkrence will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to tly 70 correct the interfererice by one or more of the following measures'
- - Reorier?t or relocate the receiving antenna.
-- Increase the separation beiween tl?e equipinent and recejver.
--Connect
the equipment into al? outleT on a cIrcGt different from that to which the (receiver is connected.
- - Consult the dealer or an experienced radio /TV technlcian for help.
Advertisement
