HomeLink CB2 series User Manual

NOTE: Some vehicles may require the ignition to be turned to the second (or "accessory")

position for programming and/or operation of HomeLink. It is also recommended that a

new battery be replaced in the hand held transmitter of the device being programmed to

HomeLink

for quicker training and accurate transmission of the radio frequency. Please

make sure that people and objects are out of the way of the moving door or gate when

programming to prevent potential harm or damage.

Wireless Control System

1. For first time programming, press and hold

2. Position the hand-held transmitter 1-3 inches

3. Using both hands, simultaneously press and hold

the two outer HomeLink buttons releasing only

when the HomeLink indicator light begins to

flash after 20 seconds. (Do not perform this

step when programming the additional

HomeLink buttons)

away from the HomeLink surface (located on

your visor, overhead console or mirror) keeping

the HomeLink indicator light in view.

both the desired HomeLink button and hand

held transmitter button. DO NOT release until

the HomeLink indicator light flashes slowly and

then rapidly. When the indicator light flashes

rapidly, both buttons may be released. (The rapid

flashing indicates successful programming)

Note: Some gate operators and garage door openers

may require you to replace step #3 with the "cycling"

procedure noted in the "Gate Operator and Canadian

Programming" section.

Table of Contents

Need help?

Do you have a question about the CB2 series and is the answer not in the manual?

Page 1 NOTE: Some vehicles may require the ignition to be turned to the second (or “accessory”) position for programming and/or operation of HomeLink. It is also recommended that a new battery be replaced in the hand held transmitter of the device being programmed to HomeLink ®...
Page 2 4. Press and hold the programmed HomeLink button and observe the indicator light. • If the indicator light is solid/continuous, pro- gramming is complete and your device should activate when the HomeLink button is pressed and released. • If the indicator light blinks rapidly for 2 sec-...
Page 3 “cycling” process to prevent possible motor burn-up. During programming, your hand-held transmitter may automatically stop transmitting. Continue to press and hold the desired HomeLink button (note steps 2-4 in the “Programming” portion on this text) while you press and re-press (“cycle”) your hand- held transmitter every two seconds until the frequency signal has been learned.
Page 4 HomeLink indicator light begins to flash after 20 seconds. Do not hold for longer than 30 seconds. HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with step 2 in the “Programming” section of this text.