Quick Installation
Basic Connection
(1) Connect the 12V DC adaptor to the power jack of the IP camera.
(2) Use Ethernet cable to make connection from the Ethernet 10/100 RJ45 socket of IP camera
to the PC.
Network Setting
After completing the basic hardware connection, make sure that the PC and the IP camera IP
address are both in the same network segment. Example: Setup preset IP camera IP to
192.168.100.100 and configure your PC IP address as the figure description below.
Setup format
IP Address 192.168.100.xxx
Subnet Mask 255.255.255.0
Default Gateway 192.168.100.1
※
N ote
xxx address ranges from 1~254, please
avoid using "100" which has been used
by IP camera.
- 7 -