Summary of Contents for CASI RUSCO 660
- Page 1 CASI-RUSCO...Security Solutions for the 21 Century Model 660 Keypad Installation Guide CASI RUSCO 1155 Broken Sound Parkway NW Boca Raton, Florida 33487 (561) 998-6100 Part Number: 460221001 Rev. C September 1998...
- Page 2 This publication may contain examples of data reports used in daily business operations. Examples include fictitious names of individuals and companies for illustration only; any similarity to names and addresses of actual business enterprises and persons is entirely coincidental. This document is distributed on an as is basis, without warranty either expressed or implied.
-
Page 3: Table Of Contents
Contents Introduction ....................1 Product Features..................1 Connecting the Keypad ................2 Programming the Keypad................. 6 Testing the Keypad ..................7 Technical Specifications................8 Functional Specifications................9 Model 660 Keypad... - Page 4 Model 660 Keypad...
-
Page 5: Introduction
Introduction This manual is an installation guide for the CASI-RUSCO Model 660 Keypad. The Model 660 uses 26-bit Wiegand technology. The Model 660 features an audible keypad; an annunciator beeps with each key press. Note: PIN (Personal Identification Number), as referenced in this Installation Guide, is the Badge Number in the host system. -
Page 6: Connecting The Keypad
Connect to black wire. Ground at keypad installation point; do not ground through cable. c. Pressing any keypad button will generate a 30-second, 0.25-amp output to ground. (This can be used to activate a CCTV or similar device.) Model 660 Keypad... - Page 7 FIGURE 1: Pinout Diagram JUMPER MUST BE INSTALLED IF PRESENT BROWN YELLOW PINK BLACK ORANGE (NO CONNECTION) BLUE WHITE GREEN Note: If you cannot find a color, go by the position in the connector. Model 660 Keypad...
- Page 8 FIGURE 2: Wiring Diagram, Model 660 26-bit Wiegand Output Model 660 Keypad...
- Page 9 Model 660 Keypad...
-
Page 10: Programming The Keypad
This procedure may be repeated to change the site code. Factory default is 000. NOTE: If you have an older Model 660 Keypad (YELLOW wire), it has been preprogrammed with the site codes “0000” and “0001.” Leaving the yellow wire disconnected results in a site code of “0000.” Connecting the yellow wire to the black wire (ground) results in a site code of “0001.”... -
Page 11: Testing The Keypad
Follow the steps below to verify that the keypad is working correctly. Check all cabling and electrical connections from the keypad to the microcontroller. See Figure 2, “Wiring Diagram, Model 660 26-bit Wiegand Output,” on page 4. Verify that the microcontroller is properly configured. See the appropriate CASI-RUSCO microcontroller manual. -
Page 12: Technical Specifications
The keypad is supplied with an eight-wire pigtail. On one end is Pinouts: a keyed connector that mates with the connector on the back of the keypad. The other ends are stripped, ready for connection to the field wiring using a terminal block or in-line splice connectors. Model 660 Keypad... -
Page 13: Functional Specifications
A sealing gasket is provided for weather proofing outdoor installations. Red and green LEDs and a beeper are incorporated into the Indicators: keypad. • Power LED. Red LED: • Indicates that the microcontroller has activated the door Green LED: strike. Model 660 Keypad... - Page 14 NOTES Model 660 Keypad...
Need help?
Do you have a question about the 660 and is the answer not in the manual?
Questions and answers