Table of Contents
Advertisement
2.1
Broadcom NetXtreme Ethernet Boot Agent
The Broadcom NetXtreme Ethernet Boot Agent provides hardware-based Ethernet card
configurations.
To start the Broadcom NetXtreme Ethernet Boot Agent and access the main screen:
1.
Turn on the system.
2.
During POST, press <Ctrl+S> when the following screen appears.
Broadcom NetXtreme Ethernet Boot Agent
Copyright (C) 2000-2013 Broadcom Corporation
All rights reserved.
Press Ctrl-S to enter Configuration Menu
3.
From the Device List screen, use the up/down arrow key to select an Ethernet device
to configure then press <Enter>.
Comprehensive Configuration Management v7.8.21
Copyright (C) 2000-2013 Broadcom Corporation
All rights reserved.
<03:00:00> BCM57840 - C8:60:00:22:86:B7 MBA:v7.2.29 CCM:v7.8.21
<03:00:01> BCM57840 - C8:60:00:22:86:B9 MBA:v7.2.29 CCM:v7.8.21
3.
From the Main Menu, use the up/down arrow key to select an item and press <Enter>.
Comprehensive Configuration Management v7.8.21
Copyright (C) 2000-2013 Broadcom Corporation
All rights reserved.
Current Adapter:Primary, Bus=03 Device=00 Func=00, MAC=C8:60:00:22:86:B7
2-2
Select Device to Configure
[Enter]:Enter Next Menu; [↑|↓]:Next Entry; [ESC]:Quit Menu
Device Hardware Configuration
MBA Configuration
iSCSI Boot Configuration
NIC Partition Configuration
Configure MBA Parameters
[Enter]:Enter Next Menu; [↑|↓]:Next Entry; [ESC]:Quit Menu
Device List
Main Menu
Chapter 2: Boot Agent Configuration
Advertisement
Table of Contents
