Advertisement
Quick Links
Advertisement
Summary of Contents for Soneco SCS
- Page 1 ™ Soneco SCS User Guide...
- Page 2 Neither Soneco Oy Ltd nor the authors who have participated in the making of this document shall be liable for any direct or indirect damages to humans, machinery,...
- Page 3 ™ QUICK GUIDE SCS Microphone Function button Speaker A picture of the device, function button, indicator lights, microphone, speaker, charger connector (on the side of the device) Press the function button. − The SMS is sent and Call connected straight to the same pre-programmed number.
- Page 4 ™ Soneco SCS User guide: The purpose of this user guide is to familiarise you with the device, its user interface and the routines you will need in daily use. It is important to learn to use and understand the user interface and its different indicators: the indicator lights and sound signals.
- Page 5 ™ User interface: Microphone Function button Speaker A picture of the device, function button, indicator lights, microphone, speaker, charger connector (on the side of the device) Preparation for use: Before you can begin to use the device, you have to install your personal SIM card without a PIN code request in the device and charge the battery.
- Page 6 This is repeated about every 45 seconds, until the battery is charged or becomes fully discharged. In addition, Soneco SCS sends an SMS message (“BATTERY 20 %”) to the first phone number set in the device half an hour after the low battery warning begins, if the charging does not begin before that.
- Page 7 The device gives a sound signal (bip) when you press the button. Release the button when the yellow light begins to blink. Soneco SCS then gives a sound signal (bip). If you have not set any phone numbers in the device, it automatically enters the number setting mode when it is switched on.
- Page 8 Phone calls: When Soneco SCS is in the standby mode you can make phone call to pre-programmed number and receive incoming calls. Except for emergency call, you can make phone call only when the device is within the coverage area of your own operator’s GSM network.
- Page 9 Answering a call: Soneco SCS indicates an incoming call with a melodic ring tone and by blinking all the three indicator lights in turn. To answer the call, briefly press the function button. The green indicator light burns continuously when the received call is active.
-
Page 10: Warranty Clause
20 cm. Warranty: Soneco Oy Ltd is not responsible for faults in the device caused by incorrect or careless use or use that is contrary to this user guide, or connection of the device to another device, or if the device has been repaired, opened, or otherwise modified or installed incorrectly. - Page 11 If the user wishes to invoke the warranty granted by Soneco Oy Ltd, the user has to present a legible receipt of purchase to Soneco Oy Ltd or the retailer of the device. The user has to invoke the warranty regarding a...
- Page 12 SIM card: 3,0 V SAR: < 0,5 W/Kg Operating voltage: 3.7 V Patented 0523 Declaration of conformity: Soneco Oy Ltd hereby declares that the product Soneco SCS is in compliance with the requirements of the European Council directive 1999/5/EY. www.soneco.fi...
Need help?
Do you have a question about the SCS and is the answer not in the manual?
Questions and answers