Spyard 960 Operating Instructions

Spy pen camera

Advertisement

Quick Links

SPYARD® Spy Pen Camera Operating Instructions & Tips
STEP 1 – GETTING STARTED
Charging Your Cam Pen (First time only, charge for 1 – 2 hours, thereafter, it's usually a 15‐minute recharge)
 Plug the USB cable into the pen's camera USB port and plug the other end into your computer USB port (see
illustration). During charge the red indicator light will flash slowly. First‐Time Charge 1-2 Hours!
 Disconnect the pen from your USB cable/port once the charge is complete
 A fully charged pen will have about 1.5 hours of recording time.

Recharging Your Cam Pen

 Recharge your pen as needed — usually approximately 15 minutes.
 Your pen's indicator LED will blink slowly while recharging. Once indicator light turns SOLID RED, pen is fully charged.

Insert the Micro SD Memory Card

 Gently, but firmly, slide the micro SD card into the slot adjacent to the USB cable slot (see illustration). You should feel
solid resistance when the SD card is fully inserted. About 1/8" of the SD card will show when inserted correctly. You are
now ready to use your pen.
Note: The Cam Pen will not work without the micro SD memory card. All recordings/photos are stored on the SD card.
In the case the pen does NOT display a solid LED during charge (i.e. continues to flash), remove the top cap part where
the On/Off button is and inspect the button. Likely the On/Off button keeps pressuring onto the On/Off switch beneath it.
Try charging then pen without the On/Off button cap back in place.
TIPS & TRICKS
 Ensure the micro SD card is pushed in completely or it will not collect data during the recording session.
 The indicator light will blink red to indicate an SD card error. (This typically means the SD card is inserted incorrectly).
 Your SD card's memory capacity (4GB - 8GB ‐ 16GB - 32GB) will determine how much data can be recorded.
 Your pen has a rechargeable lithium battery - can record up to 2 hours of recording time for videos, sound and photos.
 Recharge your pen as needed (See "Recharging Your Cam Pen" instructions above).
STEP 2 – TURN ON THE SPY PEN
 Power up your pen by pressing the On/Off Button (see illustration) for 3 seconds
 To power off, press On/Off Button for 6 seconds.
 Check indicator LED. A SOLID YELLOW (or
 READY STANDBY MODE means you can start taking videos/photos.
For more information visit our online store at
Customer Support:
Revision 5
Get to Know Your SPYARD® Pen Components
GREEN
or RED) LED means your pen is in READY STANDBY MODE.
www.spypenyard.com
support@spypenyard.com or support@spyard.com
(SOLID RED
indicator light).
or
www.spyard.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 960 and is the answer not in the manual?

Questions and answers

Summary of Contents for Spyard 960

  • Page 1 SPYARD® Spy Pen Camera Operating Instructions & Tips Revision 5 Get to Know Your SPYARD® Pen Components STEP 1 – GETTING STARTED Charging Your Cam Pen (First time only, charge for 1 – 2 hours, thereafter, it’s usually a 15‐minute recharge) ...
  • Page 2  To stop, simply click the On/Off button and pen will go back to READY STANDBY mode. NOTE: This feature is temporarily not available with your SPYARD pen. STEP 7 – VIEWING YOUR RECORDINGS AND PHOTOS  Unscrew the top of the pen to expose the USB port (see illustration).
  • Page 3 Note: You may wish to download the most recent version of VLC Player. It can be downloaded for free at http://www.videolan.org. Special Notes: A few important points about your SPYARD® Pen you should be aware of: a. Recording Situations: please comply with the relevant state laws strictly. The product shall not be used for illegal purposes.

Table of Contents