Uhf Receiver - Nova Electronics Aquapower User Manual

1.a CONTROLS 1.a CONTROLS 1.a CONTROLS 1.a CONTROLS
1. LCD display indicating the channel and the receive
frequency
2. Indicator of A/B Diversity.
3. Indicator of the RF reception: lit if it is enabled and a suitable
transmitter to the same frequency of the receiver.
4. AF indicator indicating the incoming audio signal: switched
on while receiving an audio signal from the transmitter.
5. SET button to set the receive channel and to confirm your
choice.
6. Arrow Keys:
- To set a desired channel, increasing with
∇
descending with
- By pressing one of the two arrows, the display (1) will
show the frequency instead of the channel number.
7. On / off switch and volume control audio output from the
module itself.
1.b 1.b 1.b 1.b IMPORTANT FOR USE IMPORTANT FOR USE
IMPORTANT FOR USE IMPORTANT FOR USE
The module complies with all required directives of the EU and is
C
therefore marked
•
Protect the module from direct contact with water, high
humidity and heat (admissible ambient temperature range
from zero to 40 ° C..
•
In case of improper use, incorrect connections, of misuse
or repair not performed in a workmanlike manner, NOVA
ELECTRONICS assumes no liability for any consequential ELECTRONICS ELECTRONICS ELECTRONICS
damage to persons or property and do not assim no
guarantee for the module ..
1.c 1.c 1.c 1.c OPERATION OPERATION OPERATION OPERATION
1. Turn on the receiver module with on / off switch and
volume control (7). The display (1) indicates the reception
channel set. The light A / B (2) lights up red or green
depending on antenna A or B active.
20

1. UHF RECEIVER

∆
and
NOVA NOVA NOVA
2. Still leave off the transmitter to match. Select one of the 16
available frequencies or channels that are free from
interference:
a. Press the SET button (5) The channel indication blinks
on the display.
b. While the memory channel number is blinking (for 10
seconds approx. ) With the buttons and ∆ and ∇ (6)
you can choose the channel: botton ∆ to select in
ascending order and ∇ yo select in descending
order.
c. Confirm the choice of channel with the SET button (5).
(if not confirmed within 10 seconds with the SET key
the desired channel, the module returns to the
channel previously set).
If, after the choice of the channel, with the transmitter turned off, the
light comes on RF (3), means that this channel are received or signal
interference from other transmitters. In this case, setting another
channel on the receiver module free from external disturbances..
3. To view the receive frequency of the channel set, hold the
button ∆ or ∇ . While pressing one of the buttons, the
display shows the frequency instead of the channel.
4. Turn the transmitter on and set to the same channel of
the receiver module. RF indicator lights up (3) indicating that
you are receiving a radio signal. It AF indicator lights (4), if
the transmitter displays with radio frequency set, an audio
signal with a sufficient level.
5. With the control (7) to set the audio output level of the
module.
1.d 1.d 1.d 1.d DATASHEET DATASHEET
DATASHEET DATASHEET
Tipo di ricevitore:
Frequencies:
Range:
Audio Signal:
Bandwidth:
Dimensions (l x h x p):
Weight:
THE RECEIVER MODULE HAS ALREADY RUBBER' S ANTENNAS (SEE
PICTURE)
21
PLL 16 channels Diversity
Receiver
863.100 - 864. 9 00 MHz
about 30 mt
0 – 130 mV
70 - 16.000 Hz
88 x 37 x 134 mm
110 gr