Protection One 6148PL2 Installation Manual

Keypad Features
Backlit Display
Dedicated Function Keys
Built-in Sounder
Notes 1. Permanent display backlighting is an option on some controls (see the control's instructions for details).
GENERAL INFORMATION
The 6148PL2, 6150PL2, and 6160PL2 are addressable
Remote Keypads designed for use with the Protection One
250P1 control panel. Addresses are set via the keypad keys
(no DIP switches).
The keys on the keypads are continuously backlit for
convenience.
KEYPAD DISPLAYS AND LEDS
The keypads have the following display features:
Fixed 2-line
Model Word Alpha
Display Display
6148PL2 X
6150PL2 X
6160PL2
The following table shows the LEDs and their functions:
LED Function
Red Lights when the system is armed in any mode
Green Lights when the system is "ready" to be armed.
SPECIAL FUNCTION KEYS
The keypads also feature function keys. These keys may be
programmed for panic alarms or other special functions
such as macros. See the control's instructions for details.
The 6148PL2 uses the key pairs only.
Function keys must be held down for at
least 2 seconds to activate an alarm, key
pairs activate immediately.
6150PL2&6160PL2
A ([1] & [*])
B ([*] & [#])
C ([3] & [#])
D
INSTALLATION GUIDE
6148PL2
Fixed-Word
NO
NO
Piezo
2-digit Custom
Zone Zone
Identifier Descriptors
X
X
X
6148PL2
[1] & [*]
[*] & [#]
[3] & [#]
NONE
6150PL2
Fixed-Word
YES (See Note 1)
Piezo
WIRING AND INSTALLATION
The keypads can be surface mounted directly to a drywall, or to
a single- or double-gang electrical box.
1. Remove the case back by pushing down two "snaps."
See diagram below.
2. Route wiring from the control panel through the
opening in the case back.
3. Mount the case back to a wall or electrical box.
4. Wire directly from the keypad's terminal block to the
terminal block on the control board. Wire functions are
marked next to terminals. Labels are as follows: DI Data
In to Control Panel, - Ground, + Aux. Power Plus, DO Data
Out of Control Panel. See the control panel's Installation
Instructions for more complete details.
5. Re-attach the keypad to its case back.
X
ARMED
READY
REMOVE CASE BACK BY PUSHING IN THE 2 SNAPS
ALONG KEYPAD'S BOTTOM EDGE AND PULLING THE CASE APART.
REMOTE KEYPADS
6148PL2, 6150PL2, & 6160PL2
YES
2
1
OFF AWAY
4 5
MAX TEST
7 8
INSTANT CODE
0
*
READY
K3590-2V1 2/00
6160PL2
2-Line Alpha
YES (See Note 1)
YES
Speaker
3
STAY
6
BYPASS
9
CHIME
#